Denon DVM-2845CI Operating Instructions Manual

Denon DVM-2845CI Operating Instructions Manual Manual pdf 12 page image

ENFUNCTIONAL OVERVIEWLoading the BatteriesDisplays During Operation1. Open the battery compartment cover.2. Insert two “AA” (R6P) batteries, with each oneoriented correctly.3. Close the cover.Power onNo disc inserted orcannot readHDMI output mode(480p) is selectedTray openTray closedLoading the DiscPower offHDMI output mode(720p) is selectedHDMI output mode(1080i) is selectedHDMI output mode(OFF) is selectedSuper Audio CD setup(2CH AREA) selectedSuper Audio CD setup(MULTI-CH AREA) selectedProgram playbacksetting disc is selectedProgram playback issetProgram playback settinggroup (folder) is selectedProgram playback settingALL CLEAR is selectedRandom playback isset5 Disc randomplayback is setAll group playbackis setHDMI output mode(1080p) is selectedTray rotationAC cord plugged inCautions On Batteries• Use “AA” (R6P) batteries in this remote control unit.• Replace the batteries with new ones approximately oncea year, though this depends on the frequency with whichthe remote control unit is used.• If the remote control unit does not operate within a closeproximity of the main unit, replace the batteries with newones, even if less than a year has passed.• The included batteries serve only for verifying operation.Replace them with new batteries as soon as possible.• When inserting the batteries, be careful to do so in theproper direction, following the and marks in theremote control unit’s battery compartment.• To prevent damage or battery fluid leakage:• Do not mix a new battery with an old one.• Do not mix two different types of batteries such asalkaline and manganese.• Do not short-circuit, disassemble, heat or dispose ofbatteries in flames.• Remove the batteries when not planning to use theremote control unit for a long period of time.• If the batteries should leak, carefully wipe off the fluid from theinside of the battery compartment, then insert new batteries.NOTES:• The front panel display has blinked while setting theprogram playback.• “P**-●●●” is displayed on the front panel display whilesetting the program playback. (“**” is program number,“●●●” is track number.)• “A” is displayed on front panel display while selecting theaudio file (CD, MP3, WMA, Super Audio CD, DVD-Audio).• “F-***” is displayed on the front panel display while selectingthe group (folder). (“***” is group (folder) number.)• “A-CLEAr” is displayed on the front panel display whileselecting ALL CLEAR.• “SHUFFLE” is displayed on the front panel display whilesetting the random playback.• “5-SHUFF” is displayed on the front panel display whilesetting the 5 Disc random playback.• “A-PLAY” is displayed on the front panel display whilesetting the all group playback.1 24 53DISC16 feet (5m)30˚23 feet (7m) 16 feet (5m)30˚Keep in mind the following when using the remote control:• Make sure that there are no obstacles between the remotecontrol and the remote sensor on the unit.• Remote operation may become unreliable if strong sunlight orfluorescent light is shining on the remote sensor of the unit.• Remote control for different devices can interfere with eachother. Avoid using remote control for other equipment locat-ed close to the unit.• Replace the batteries when you notice a fall off in the oper-ating range of the remote control.• The maximum operable ranges from the unit are as follows.- Line of sight: approx. 23 feet (7m)- Either side of the center: approx. 16 feet (5m) within 30˚- Above: approx. 16 feet (5m) within 15˚- Below: approx. 10 feet (3m) within 30˚Using a Remote Control– 12 –