Denon DVM-2845CI Operating Instructions Manual

Denon DVM-2845CI Operating Instructions Manual Manual pdf 13 page image

– 13 – ENEnglish1. CONTROL CONNECTOR (RS-232C)This is a terminal for future system expansion.2. HDMI OUT JackUse an HDMI connection cable (commercially available) to connect to a display with an HDMI compatible port.3. 5.1ch AUDIO OUT JacksUse speaker cables (commercially available) to connect these jacks to the 5.1 ch Audio input jacks of your AV amplifierwith 5.1-channel input terminals.4. AUDIO OUT JacksConnect to the Audio input jacks of A/V-compatible TV or wide screen TV, Stereo system.5. DIGITAL OUT JacksUse either an optical or coaxial digital cable (commercially available) to connect to an AV amplifier with a built-indecoder (AV control center).6. VIDEO OUT JackUse a video cable to connect one of the jacks to Video input on your A/V-compatible TV, wide screen TV, or Stereo system.7. COMPONENT VIDEO OUT JacksUse a Component Video cable (commercially available) to connect these jacks if you have a TV with Component Videoin jacks. These jacks provide C B/P B, CR/P R and Y video. Along with S-Video, Component Video provides the best qualitypicture.8. S-VIDEO OUT JackUse the S-Video cable (commercially available) to connect this jack to the S-Video jack on your A/V-compatible TV orwide screen TV for a higher quality picture.9. REMOTE CONTROL IN/OUT JacksConnecting the DENON Satellite Remote Control to these jacks enables you to operate more than one DENON compo-nents with one remote control.When using the DENON Satellite Remote Control,1. Connect the DENON Satellite Remote Control to the REMOTE CONTROL IN jack of this player. This allows you to oper-ate this player with the Satellite Remote Control.2. Connect another DENON component to the REMOTE CONTROL OUT jack of this player. This allows you to operate thisplayer and the connected component with the same Satellite Remote Control.NOTE:• When there is video output from the HDMI OUT jack, no signal is output from the COMPONENT VIDEO OUT jacks.Selecting Progressive Scan (525p/480p or Interlaced 525i/480i) Playback¡If your TV is compatible with progressive scanning (525p/480p), connect the TV to the COMPONENT VIDEO OUT jacks ofthe DVD player and set PROGRESSIVE to ON in the DISPLAY setting. Next, set your TV to the progressive scan mode.Refer to page 31 for instructions on changing the display setting. P.SCAN will appear on the display of the unit.¡If your TV is not compatible with progressive scanning, set PROGRESSIVE to OFF (refer to page 31). Make sure that P.SCANon the display of the unit lights off.¡Use a commercially available adaptor if the video input jacks of your TV or monitor is the BNC type.¡Progressive video signal will not be output from the COMPONENT VIDEO OUT during the HDMI output mode.What is Progressive Scanning?¡Unlike conventional interlace scanning, the progressive scan system provides less flickering and images in higher resolutionthan that of traditional (525i/480i) television signals.CONNECTIONSDescription - Rear PanelManufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarksof Dolby Laboratories.1 2 3 4 5 6 7 98The DCDi (Directional Correlational Deinterlacing) system of this DVD player produces smooth andnatural video images, even if really dynamic, by eliminating the jagged edges. *“DCDi” is a trademarkof Faroudja, a division of Genesis Microchip Inc.“DTS” and “DTS Digital Surround” are registered trademarks of DTS, Inc.