Before using the remote control unitThe remote control unit has a built-in lithium battery.Pull out the insulation sheet before use. .o Replacing the battery1. Pull the groove on the left side of the battery case at the bottom ofthe reverse side of the remote control unit to the right.2. In this state, pull the battery case downwards. .3. Insert the lithium battery (CR2025) correctly into the batterycompartment as indicated.4. Replace the battery case in the original position. .NOTE0 When inserting the lithium battery, be sure to do so in the proper direction,following the q and w marks in the battery compartment.0 If the battery should have a leakage, immediately replace and dispose of thebattery. In this case, there is a risk of burn when the liquid comes in contactwith skins or clothes, so a great care should be taken. If the liquid accidentallycomes in contact, wash with tap water and consult a doctor.0 Remove the battery from the remote control unit if it will not be in use for longperiods.Contents Setup Use Troubleshooting Status LED Appendix20
