My HEOS device turns off and the status LED flashes in redSolution Refer to Page0 The protection circuit has been activated due to a rise in temperature within your HEOS device. Turn the power off, wait aboutan hour until this device cools down sufficiently, and then turn the power on again.–Music cuts out or delays sometimesSolution Refer to Page0 Make sure your Internet connection is operating correctly. If you are sharing your network with other users or devices, they maybe using most of your bandwidth (especially if they are streaming video).70 Make sure your HEOS devices are within range of your wireless network. 600 Make sure your HEOS devices are not located near other electronic devices that could interfere with it’s wireless connectivity(like microwave ovens, cordless phones, TVs, etc…).60I hear a delay when using the external input with my TVSolution Refer to Page0 If you are connecting the External input with your cable or satellite box for enjoying TV audio through multiple HEOS devices,you may hear a delay between when you see someone speak and when you hear the audio. This is because the HEOS systemmust buffer the audio before it sends it out to the HEOS devices so that it arrives at all devices at the same time.－0 You can avoid this delay by listening only to the device which is directly connected to the set top box. －Contents Setup Use Troubleshooting Status LED Appendix64
