I hear distortion when using the AUX inputSolution Refer to Page0 The analog output signals from some sources can be fairly strong. If the input level of the source device is turned up high, itcould overload the inputs of the HEOS device. This is unlikely to cause damage, but can cause distorted sound. Initially, set thevolume of the source to a medium – low level, then turn it up as needed. If you hear distortion, turn down the device’s volumecontrol.－Connecting to a WPS networkSolution Refer to Page0 If your wireless router support WPS (Wi-Fi Protected Setup™) your HEOS wireless device can optionally connect to yournetwork using the “Push Button” method by following these steps:Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.1. Press the WPS button on your router.2. Within 2 minutes, press and hold the Connect button on the rear panel of the HEOS device for 3 seconds.3. The LED on the front of the device will flash green for several seconds as it connects to your WPS router.4. When the connection is complete, the LED on the front of the device will turn solid blue.7Contents Setup Use Troubleshooting Status LED Appendix65
