9ENGLISHEasy Setup and Operation Easy Setup and OperationENGLISHStarting Auto Setup2 Press the CURSOR DD or HH button to select“Auto Setup”, then press the ENTER button.• The “Auto Setup” screen appears.1 Press the SETUP button.• The “System Setup” menu appears.When “S. Back” is selected, the test tone during AutoSetup will be output from the Surround back speaker.When “Bi-Amp” is selected, change the setting to “Bi-Amp”. The test tone during Auto Setup is set so that it willbe output from the Bi-Amp speaker.3 Press the CURSOR DD or HH button to select“Power Amp Assign”, then press the CURSOR FFor GG button to select “S. Back” or “Bi-Amp”.Measurement of each channel is performed as follows:4 Press the CURSOR DD or HH button to select“Start”, then press the CURSOR FF button.• Start the measurements.FL FR C SW SL SR SBL SBR1 2 31: Only the front speakers (A) are measured, frontspeakers (B) are not available. Even if the frontspeakers (B) are set, the setting automaticallyswitches to the front speakers (A) oncemeasurements are completed.2: The subwoofer speaker is measured twice.3: When “Bi-Amp” is selected, these are not displayed.After each channel is measured, “Calculating”appears.The display switches to the Auto Setup check screenautomatically.• Measurement is canceled if the MASTER VOLUME control knobis operated while the Auto Setup is performed.• If the output volume and crossover frequency of yoursubwoofer speaker can be changed, then set the volume tohalfway and the crossover filter to maximum or switch offthe low-pass filter.2 About automatic retryTo confirm the results of the measurements, remeasurement isautomatically performed.Remeasurement is performed up to 2 times. During this time,“Retry1” or “Retry2” is displayed on the screen.NOTE:• When measurements have been made using themeasurement microphone, speakers with built-in filters,such as a subwoofer, might be set to a value that differsfrom the physical distance because of the internal electricaldelay.