Denon avr-2106 Operating Instructions Manual

Also see for AVR-2106: Operating instructions Control protocol Operating instructions Brochure & specs Operating instructions

27ENGLISHBasic Operation Basic OperationENGLISHAuto tuner presetsListening to the radioAuto preset memoryHold the PRESET • button and press the POWERswitch on the main unit.• The unit automatically begins searching for FM broadcaststations.• This unit is equipped with a function for automatically searchingfor FM broadcast stations and storing them in the presetmemory.• The “Auto tuner preset” operation can also be performed at“System setup” ( page 38).When the first FM broadcast station is found, that station isstored in the preset memory at channel A1.Subsequent stations are automatically stored in order atpreset channels A1 to A8, B1 to B8, C1 to C8, D1 to D8, E1to E8, F1 to F8 and G1 to G8 for a maximum of 56 stations.Channel A1 is tuned in after the auto preset memoryoperation is completed.• If an FM station cannot be preset automatically due to poorreception, use the “Manual tuning” operation to tune in thestation, then preset it using the manual “Preset memory”operation.• To interrupt this function, press the ON/STANDBY switch.2 DEFAULT SETTINGSA1 ~ A8 87.5 / 89.1 / 98.1 / 108.0 / 90.1 / 90.1 /90.1 / 90.1 MHzB1 ~ B8 522 / 603 / 999 / 1404 / 1611 kHz,90.1 / 90.1 / 90.1 MHzC1 ~ C8 90.1 MHzD1 ~ D8 90.1 MHzE1 ~ E8 90.1 MHzF1 ~ F8 90.1 MHzG1 ~ G8 90.1 MHz• When in the auto tuning mode on the FM band, the “STEREO”indicator lights on the display when a stereo broadcast is tunedin. At open frequencies, the noise is muted and the “TUNED”and “STEREO” indicators turn off.3 Press the MODE button to set the auto tuningmode.4 Press the TUNING (+) or (–) button.Automatic searching begins, then stops when a station istuned in.SHIFT TUNINGON/STANDBYPOWERFUNCTION PRESETBANDSHIFTMODEMEMORYBANDTUNERON SCREENPRESETTUNING1 Set the input source to “TUNER”.(Main unit) (Remote control unit)2 Watching the display, press the BAND button toselect the desired band (AM or FM).Auto tuningManual tuning1 Set the input source to “TUNER”.3 Press the MODE button to set the manual tuningmode.Check that the display’s “AUTO” indicator turns off.2 Watching the display, press the BAND button toselect the desired band (AM or FM).