Denon avr-2106 Operating Instructions Manual

Also see for AVR-2106: Operating instructions Control protocol Operating instructions Brochure & specs Operating instructions

31Advanced OperationENGLISHPreset memory1 Set the MODE 1 switch to “AUDIO” or “VIDEO”.2 Set the MODE 2 switch to the component to beregistered.Advanced Operation• DENON and other makes of components can be operated bysetting the preset memory.• This remote control unit can be used to operate components ofother manufacturers without using the learning function byregistering the manufacturer of the component as shown in thelist of preset codes ( End of this manual).• Operation is not possible for some models.Set to the AUDIO side for the CD, Tape deck or CDR/MDposition, and to the VIDEO side for the DVD/VDP,DBS/CABLE, VCR or TV position.• The signals for the pressed buttons are emitted while settingthe preset memory. To avoid accidental operation, cover theremote control unit’s transmitting window while setting thepreset memory.• Depending on the model and year of manufacture, this functioncannot be used for some models, even if they are of makeslisted in the list of preset codes.• Some manufacturers use more than one type of remote controlcode. Refer to the included list of preset codes to change thenumber and verify correct operation.• The preset memory can be set for one component only amongthe following: CDR/MD, DVD/VDP and DBS/CABLE.2 The preset codes are as follows upon shipment from thefactory and after resetting:• TV, VCR .........................................HITACHI• CD, TAPE.......................................DENON• CDR/MD ........................................DENON (CDR)• DVD/VDP .......................................DENON (DVD)• DBS/CABLE...................................ABC (CABLE)Operating a component stored in the presetmemory1 Set the MODE 1 switch to “AUDIO” or “VIDEO”.2 Set the MODE 2 switch to the component youwant to operate.3 Operate the component.For details, refer to the component’s operating instructions.Some models cannot be operated with this remote controlunit.Set to the AUDIO side for the CD, Tape deck or CDR/MDposition, and to the VIDEO side for the DVD/VDP,DBS/CABLE, VCR or TV position.MODE 2ON SOURCEMODE 1NUMBEROFF3 Press the ON/SOURCE and OFF button at thesame time.• The indicator starts flashing.4 Referring to the included list of preset codes,press the NUMBER buttons to input the presetcode (a 3-digit number) for the manufacturer ofthe component whose signals you want to storein the memory.5 To store the codes of another component in thememory, repeat steps 1 to 4.ENGLISH