Desa EFS10TNA Owner's Operation And Installation Manual

Also see for EFS10RNA: OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com 112462-01B14Assembling Trim (Trim shipped withmantel)1. Remove packaging from three remainingpieces of trim.2. Locate two adjusting plates with set screws,and two shims in the hardware packet.3. Align shim under adjusting plate as shown inFigure 13.4. Slide one end of adjusting plate/shim in sloton mitered edge of top trim (see Figure 13).5. Slide other end of adjusting plate/shim in sloton mitered edge of side trim (see Figure 13).6. While firmly holding edges of trim together,tighten both set screws on the adjusting platewith slotted screwdriver.7. Repeat steps 1 through 6 for other corner.8. Set assembly aside for later installation.Figure 13 - Assembling TrimSide TrimTop TrimMitered EdgeShimSetScrewsAdjusting PlateSlotFigure 14 - Removing Upper LouverBlowerBracketMountingHolesINSTALLING OPTIONAL BLOWERACCESSORY GA3450TRemoving Upper LouverTo install the blower accessory, you must first re-move the upper louver.1. Lift screen off fireplace and remove log set ifinstalled.2. Remove 4 screws from upper louver (see Fig-ure 14). Save these screws.3. Pull upper louver straight out from the cabi-net. Be careful not to scratch the paint. Setlouver and screws aside.4. Open lower louver door by swinging doordown (see Figure 15, page 15).Upper LouverINSTALLATIONContinuedInstalling Blower AccessoryNote: If you are using a mantel with your fireplace,use the following instructions. If your fireplace isbuilt-in, see For Built-In Installation, page 16.CAUTION: Label all wiresprior to disconnection when ser-vicing controls. Wiring errorscan cause improper and dan-gerous operation.CAUTION: Verify proper op-eration after servicing.1. Locate fan switch cover. Remover bottomscrew to remove back portion of the cover.2. Install snap bushings found in hardware kitinto both holes in rear of fan switch cover.3. Make sure the wire harness is firmly con-nected to the terminals on the blower bracketassembly.4. Note the wire locations on back of AUTO/OFF/ON switch. The terminals on back ofswitch are numbered 1, 2, and 3. Carefullyremove red wire from terminal 3 and blue wirefrom terminal 1. Black wire can remain onmiddle terminal 2 (see Figure 15, page 15).5. Carefully disconnect green and white wiresat their insulated connectors (see Figure 16,page 15).