Desa EFS10TNA Owner's Operation And Installation Manual

Also see for EFS10RNA: OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com 112462-01B1610. Route power cord out of the cabinet by in-serting it through the bushing on the outer cas-ing (see Figure 15, page 15). Plug fan kit into120-Volt grounded power supply and test op-eration.Note: When switch is in the AUTOposition, the fan will start after the fireplacehas run for a few moments. The fan will con-tinue to run for several moments after the fire-place has been turned off. When switch is inthe ON position, the fan will run until turnedto OFF. Reinstall upper louver (see Figure 14,page 14). Close lower louver door.INSTALLATIONContinuedRedRedFan Switch(Auto/Off/On)BlueBlueThermostatSwitch(N.O.)GreenWhiteGreenWhiteOn110/115V.A.C. BlowerMotorBlackOff123AutoFigure 18 - Wiring Diagram For BlowerAccessory Built-In InstallationFor Built-In InstallationWARNING: A licensed elec-trician must connect the wiringharness to electrical supply fol-lowing all local codes. Electri-cian must provide a clamp onthe box cover to secure the wir-ing. Wiring should be routedthrough the bushing in the holeon the outer casing of fireplace.1. Locate fan switch cover. Remove bottomscrew to remove back portion of the cover (seeFigure 17).2. Install a snap bushing found in hardware kitinto one of the holes on rear of fan switch cover.The other hole is for a strain relief clamp (notsupplied) to secure incoming electrical supply.3. Follow steps 3 through 7 in Installing BlowerAccessory, page 14.4. A licensed electrician must follow the wiringdiagram to connect incoming electrical sup-ply to fan kit wiring harness (see Figure 18).Figure 17 - Installing Switch Plate to FanSwitch CoverSwitchCoverScrewScrewRear -FanSwitchCoverFront - FanSwitch CoverSwitch Plate5. Install the switch plate on front of fanswitch cover with 2 #10 screws provided(see Figure 17). Using screw removed instep one, reconnect front and rear of fanswitch cover.6. Plug power cord to the outlet receptacle (notprovided) as shown in Figure 19, page 17. Windextra cable of power cord and tie it up with theplastic wire strap (see Figure 19, page 17). Setthe cable bundle between the fan switch boxand outer casing, away from the burner.7. Test to make sure the blower is workingproperly.8. Reinstall upper louver (see Figure 14, page14) and close lower louver.Extension CordUse extension cord if needed. The cord must have athree-prong, grounding plug and a three-hole recep-tacle. Make sure cord is in good shape. It must beheavy enough to carry the current needed. An under-sized cord will cause a drop in line voltage. This willresult in loss of power and overheating. Use a No.16 AWG cord for lengths less than 50 feet.