Dynex DX-24E310NA15 User Manual

Also see for DX-24E310NA15: Quick setup guide

Contents

16 Dynex 24" LED TVDX-24E310NA15www.dynexproducts.comConnecting an antenna or cable TV (no box)1 Make sure that your TV’s power adapter is unplugged and all connected equipment is turned off.2 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the side of your TV and to the antenna or cable TVwall jack.3 Plug your TV’s power adapter into a power outlet, then turn on your TV.4 Press INPUT to open the INPUT SOURCE list.5 Press S or T to highlight TV, then press ENTER.6 If you cannot tune to channels you know exist, scan for channels. See “Automatically scanning for channels” on page 49.Notes• Use a coaxial cable to eliminate interference and noise fromradio waves.• Do not bundle the coaxial cable with the power adapter orother cables.• If the antenna is not installed correctly, contact qualified servicepersonnel to correct the problem.• If the signal level for a channel is weak, the picture may bedistorted. Adjust the antenna or use a highly directionaloutdoor or set-top antenna with a built-in amplifier.• If the picture quality is good on some channels and poor onothers, the problem may be caused by a poor or weak signalfrom the broadcaster or cable TV provider.• If you connect to cable or satellite TV without a set-top box andexperience poor picture quality, you may need to install aset-top box to improve signal reception and picture quality.Contact your cable or satellite TV provider about upgrading toa set-top box.• Many high-definition (HD) channels upscalestandard-definition (SD) content. The picture displayed on yourTV is still displayed as SD, thus the picture quality will not be asclear or crisp as it would be if the content was originallyrecorded in HD.Coaxial cableAntenna orcable TV(no box)Side of TVCoaxial cableconnectorANT/CABLE INjackOn your TV