Dynex DX-32L150A11 User Manual

Also see for DX-32L150A11: Faqs Quick setup guide Firmware update User guide Service manual

30 MaintenanceDX-32L/37L/40L/46LGeneralNote: If the problem is not solved by using these troubleshootinginstructions, try turning off your TV, then turning it on again.MaintenanceCleaning• Clean your TV with a soft, dry cloth. If surfaces are extremelydirty, use a soft cloth dampened with a weak detergent solution.• Use an eyeglass cleaner to clean the screen. Never use alcohol,paint thinner, or benzine.• Before using a chemically treated cloth, read the instructionsthat came with the cloth.SpecificationsSpecifications subject to change without notice.Weight and dimensions shown are approximate.Legal noticesFCC Part 15This device complies with Part 15 of the FCC Rules. Operation of thisproduct is subject to the following two conditions: (1) this device maynot cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesiredoperation.This equipment has been tested and found to comply within the limitsfor a class B digital device, pursuant to Part 15 of the FCC Rules. Theselimits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates,uses, and can radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guaranteethat interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one ormore of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.• Consult the dealer or an experienced technician for help.Problem SolutionOne or more channels donot display.• Make sure that the channels arenot blocked. For moreinformation, see “Setting parentalcontrol levels” on page 22.• Make sure that the channels arenot hidden. For more information,see “Hiding channels” on page 18.• The channel may have beendeleted from the channel list. Youcan tune to the channel bypressing the number buttons oryou can add the channel back tothe channel list. For moreinformation, see “Changingchannel settings” on page 17.Password is lost. • Enter 9999 to access parentalcontrols, then set a newpassword. For more information,see “Setting parental controls” onpage 20.Some settings cannot beaccessed.• If a setting is grayed, the setting isnot available in the current videoinput mode.TV cabinet creaks. • When the TV is in use, thetemperature rises naturally andmay cause the cabinet to expandor contract which can cause acreaking noise. This is not amalfunction.Control buttons on the TVdo not work. • Disconnect the power cord, wait afew seconds, then reconnect thepower cord and turn on the TV.TV type LCDTV panel 32-inch TFT LCD37-inch TFT LCD40-inch TFT LCD46-inch TFT LCDTV system NTSC-M, ATSCReceiving channels VHF: 2 - 13UHF: 14 - 69CATV: 1 - 125CADTV: 1-135DTV: 2-69Audio multiples BTSC systemAudio out 8 W x 2 (32 ")10 W x 2 (37 "/40 " /46")Power requirement AC 120 V, 60 HzPower consumption 98 W (32")145 W (37 ")185 W (40 ")240 W (46 ")Dimensions(W × H × D with stand)30.5 × 21.5 × 8.3 inches(776 × 546 × 210 mm) - 32 "35.4 × 24.9 × 11 inches(899 × 632 × 280 mm) - 37 "38.4 × 26.4 × 11inches(976 × 670 × 280 mm) - 40 "43.7 × 29.7 × 11.8 inches(1110 × 756 × 300 mm) - 46 "Weight 23.15 lbs. (10.5 kg) - 32"31.9 lbs. (14.5 kg) - 37"44 lbs. (20 kg) - 40"48.5 lbs. (22 kg) - 46 "Input terminals Composite video/L and R audio (2)S-Video (2)Component video/L and R audio (2)HDMI (3)VGA/audio (1)Antenna (1)Output terminals Audio left and right (1)Digital optical (1)Headphone (1)Control terminals SERVICE PORT (1)