Dynex DX-R13TV User Manual

Setting up the television 93 Press the CH + and CH - buttons until the indicator next to TVCABLE flashes.4 Press the VOL + and VOL - buttons to select TV or CABLE.• TV—VHF/UHF channels• CABLE—Cable television channels5 Press EXIT to return to the normal screen.Note:It may take a few seconds for a digital channel picture to appear on screenafter being selected.Cable chartThe following chart is typical of many cable system channel allocations.The number on the top is the number on the television. The number orletter on the bottom is the corresponding cable channel.Note:Contact your cable company to identify the type of cable system used inyour area.Automatic memory tuningMemorizing channels is best accomplished during evening “primetime”hours, as more channels are broadcasting digital signals. Memorizingchannels can only be accomplished while a station is broadcasting adigital signal to set the channel into memory.If you are not sure of the digital channels available in your area, visitwww.antennaweb.org to find a list based on your address or zip code.To automatically memorize channels:1 Press MENU/ENTER. The menu screen appears.2 Press the CH + and CH - buttons until the indicator next to CHSETUP flashes, then press the VOL + button.3 Press the CH + and CH - buttons until the indicator next to AUTOCH MEMORY flashes, then press the VOL + button. The televisionbegins memorizing all of the channels available in your area.After completing analog tuning, digital tuning startsautomatically. Depending on the reception condition, it may takefrom 15 to 30 minutes to complete memorizing digital cablechannels. Depending on the condition of the reception, the BARdisplay may not advance for several minutes.Note:Some new channels may be added. You should complete the AUTO CHMEMORY procedure periodically.Adding and deleting channelsTo add or delete analog channels:1 Press TUNER to select analog mode.2 Press MENU/ENTER. The menu screen appears.3 Press the CH + and CH - buttons until the indicator next to CHSETUP flashes, then press the VOL + button.4 Press the CH + and CH - buttons until the indicator next to ADD/DELETE flashes.5 Select the desired channel to be memorized or deleted using theCH + and CH - buttons. Press the VOL + and VOL - buttons toselect ADD or DELETE.6 Repeat Step 5 for other channels you want to add or delete, thenpress MENU/ENTER.7 Press EXIT to return to the normal screen.To add or delete digital channels:1 Press TUNER to select the Digital mode.2 Press MENU/ENTER. The menu screen appears.3 Press the CH + and CH - buttons until the indicator next toDIGITAL SETUP flashes, then press the VOL + button. TheDIGITAL SETUP menu appears.4 Press the CH + and CH - buttons to select ADD/DELETE, thenpress the VOL + button.5 Press the CH + and CH - buttons again to select ADD/DELETE,then press the VOL + button.