EBS HandJet EBS 250 Operating Instructions Manual

Also see for HandJet 250: Operating manual

EBS HandJet EBS 250 Operating Instructions Manual Manual pdf 10 page image

10 EN EBS Ink-Jet Systeme 20080908#3.0ENif the printer and the accessories areinstalled and used following themanufacturer’s instructions.The HANDJET ® EBS 250 printer andRFI modules will bear the followingmark:1471Environmental protectionAfter the printer and RFImodules have been put outof service, do not take themout together with other do-mestic waste.According to Directive No 2002/96/ECof the European Council on electricaland electronic equipment waste, theHANDJET ® EBS 250 printer and RFImodules that have been put out ofservice must be separated from do-mestic waste and processed in anenvironmentally friendly way.ApplicationThe HANDJET ® EBS 250 printer isdesigned for marking, labelling, put-ting prints and simple graphics wher-ever the use of a manual labellingdevice is required or preferred.Prints are put on objects in a non-contact INK-JET way.Installing and Starting upPreparing the Printer for Opera-tionCharging the BatteryA LI-ION top-quality battery has beeninstalled in the printer. It can be re-charged at any stage of printer opera-tion.The battery that is new or has notbeen used for a long time cannot becharged up to its full capacity. There-fore, in order to form the battery followthree charge-and-then-discharge cy-cles. See figures A and C .1. Pull out plug 15 from socket 14and tilt it.2. Insert power pack connector 26to socket 14, and connect powerpack 25 to a wall outlet.3. Lamp 21 glows when the batteryis being charged. Wait until thecharging is over and lamp 21starts flashing.4. Remove the power pack plug 26and secure socket 14 with plug15. Detach the power pack fromthe mains and place it into thebag.5. Do not recharge the battery untilit is completely discharged - seeLow-battery indicator.The HANDJET ® EBS 250 printershould be stored with its batteriescharged. If the printer is to be storedfor a longer time (6 months or longer)and its batteries are not recharged, itmay work for a shorter time after ithas been recharged afterwards or incertain circumstances even stopworking. Such a phenomena iscaused by the properties of the batter-ies, which are always subject to theprocess of self-discharging. In theconsequence of self-discharging andlong-term storage in the dischargestate, the maximum capacity of thebatteries may lower or the batteriesmay get damaged completely.In order to avoid such a situation, it isnecessary to charge batteries of theHANDJET ® EBS 250 printer at leasttwice a year (however not lessfrequently than every 6 months).Otherwise, the printer may stop work-