Eaton 9155 User Manual

Also see for Powerware Series: Installation and operation manual User guide User guide User guide Installation and operation manual

Contents

COMMUNICATIONEaton 9155 UPS (8–15 kVA) User's Guide 164201553 Rev G (www.eaton.com/powerquality) 53X-Slot CardsX-Slot cards allow the UPS to communicate in a variety of networking environmentsand with different types of devices. The Eaton 9155 has two available communicationbays for any X-Slot card, including: ConnectUPS -X Web/SNMP Card - has SNMP and HTTP capabilities as well asmonitoring through a Web browser interface; connects to a twisted-pair Ethernet(10/100BaseT) network. It has a built-in switching hub that allows three additionalnetwork devices to be connected to the network without the requirement ofadditional network drops. In addition, a Environmental Monitoring Probe can beattached to obtain humidity, temperature, smoke alarm, and security information. Relay Interface Card - has isolated dry contact (Form-C) relay outputs for UPS status:Utility failure, Low battery, UPS alarm/OK, or On bypass. Modbus ® Card - allows you to continuously and reliably monitor the UPSs in yourBuilding Management System (BMS). Industrial Relay Card (IRC) - is used to indicate the operating status of the UPSsystem using the customer's monitoring equipment. The IRC uses four isolatednormally-open or normally-closed dry relay contacts to indicate the UPS status.Normal, Bypass, Battery, and Alarm mode can be monitored. Multi-Server Card - has six serial communication ports that can communicatesimultaneously with other computers using LanSafe Power Management Software(provided on the Software Suite CD). Modem Card - provides out-of-band remote notification and monitoring usingmodem communication directly to cell phones and pagers. Single-Port Card - provides serial communication. ConnectUPS-MX SNMP Card - has Ethernet, modem, and SNMP capabilities. USB Card - connects to a USB port on your computer.NOTE The Eaton 9155 does not detect plug-and-play hardware. Before installing the USB Card, set the UPSbaud rate to 1200 through the front panel (see Table 9 on page 59).See Figure 36 on page 49 for the location of the two X-Slot communication bays.Relay Interface CardModbus CardMulti-Server CardModem CardSingle-Port CardConnectUPS-X Web/SNMP CardIndustrial Relay Card ConnectUPS-MX SNMP CardUSB CardFigure 42. Optional X-Slot Cards