Eaton 9355 Installation And Operation Manual

Also see for Powerware Series: Installation and operation manual User guide User guide User guide User guide

Contents

CommunicationEaton 9355 UPS (20/30kVA) Installation and Operation Manual 164201626—Rev F www.eaton.com/powerquality 534. Route the cable(s) through the opening between the two X-Slot communication bays.Figure 38. Routing the Cables5. Remove the communication wiring access plate from the UPS rear panel and punch a hole in it using aGreenlee punch or similar device (see Figure 39).Figure 39. Communication Wiring Access6. Connect the cables to the appropriate location.See “Communication Options” on page 54 or “Control Terminals” on page 60 for detailed information.7. Reinstall the communication wiring access plate.8. Replace the UPS front door.9. Continue to “Operation” on page 69 to start up the UPS.Communication OpeningCommunicationWiring Access Plate