Eaton 9355 Installation And Operation Manual

Also see for Powerware Series: Installation and operation manual User guide User guide User guide User guide

Contents

CommunicationEaton 9355 UPS (20/30kVA) Installation and Operation Manual 164201626—Rev F www.eaton.com/powerquality 55l ConnectUPS ™ -X Web/SNMP Card - has SNMP and HTTP capabilities as well as monitoring through a Webbrowser interface; connects to a twisted-pair Ethernet (10/100BaseT) network. It has a built-in switching hubthat allows three additional network devices to be connected to the network without the requirement ofadditional network drops. In addition, a Environmental Monitoring Probe can be attached to obtain humidity,temperature, smoke alarm, and security information.l Relay Interface Card - has isolated dry contact (Form-C) relay outputs for UPS status: Utility failure, Lowbattery, UPS alarm/OK, or On bypass.l Modbus ® Card - allows you to continuously and reliably monitor the UPSs in your Building ManagementSystem (BMS).l Industrial Relay Card - is used to indicate the operating status of the UPS using the customer's monitoringequipment and to connect an optional RMP. The IRC uses four isolated normally-open or normally-closed dryrelay contacts to indicate the UPS status. Normal, Bypass, Battery, and Alarm mode can be monitored (seepage 59 for more information).l Multi-Server Card - has six serial communication ports that can communicate simultaneously with othercomputers using LanSafe Power Management Software (provided on the Software Suite CD).l Modem Card - provides out-of-band remote notification and monitoring using modem communicationdirectly to cell phones and pagers.l Single-Port Card - provides serial communication.l ConnectUPS-MX SNMP Card - has Ethernet, modem, and SNMP capabilities.l USB Card - connects to a USB port on your computer.Note: The Eaton 9355 UPS does not detect plug-and-play hardware. Before installing the USB Card, set theUPS baud rate to 1200 through the front panel (see Table 7 on page 70).See Figure 36 on page 51 for the location of the two X-Slot communication bays.Figure 41. Optional X-Slot CardsMulti-Server CardModem CardSingle-Port CarddraCPMNSXM-SPUtcennoCUSB CardRelay Interface CardModbus CardConnectUPS-X Web/SNMP CarddraCyaleRlairtsudnIPower Xpert ® Gateway Card