Eaton APS3-300 Installation And Operation Manual

Also see for SC100: Installation and operation guide Operation handbook Operation handbook

Contents

InstallationCopyright © 2007-2012 Eaton Corporation. All Rights Reserved.IPN 997-00012-48D November 2012 25Step 7 - Check terminations, secure cables and test insulation1 Check all terminations are correct and are tightened.2 Secure the cable with cable ties to ensure there is no strain on the terminals. See the diagram on page 3 for the location of the cable tie points.3 Replace the ac terminal cover. Check all conductors to the ac terminals pass through the ac cable entry gland.4 Test the insulation resistance of the conductors according to local ac wiringregulations.Procedure completeTask 4 - Mount the APS in the RackStep 1 - Check clearancesAPSs require the following minimum clearances:Front Clearance - 600mm (24") for access and unrestricted air intake.Rear Clearance - 50mm (2”) from back of rack, other equipment and cables toallow air escape route for optimum system cooling.Top Clearance - 1U (44.45mm / 1¾") minimum from other equipment in therack. Recommended for access to cable terminations.Step 2 - Fit cage nutsFit cage nuts in the correct positions to match the screw holes in the APS rackmounting brackets.