Eaton All-Pro WPS2040M Instruction Manual

1Questions?/Des questions?/¿Preguntas? 1-800-334-6871 ConsumerProducts@eaton.comInstruction Manual/Manuel d’instructions/Instrucciones• Once charged, test the system before permanently installing.• Position the motion sensor so motion moves across thedetection zone (Fig. 1).• Keep solar panel clear of any objects that will blockthe sunlight. It will be necessary to periodically cleanthe solar panel with soft wet cloth.INSTALLATIONSolar Panel1. Assemble the solar panel mounting bracket (Fig 2):- Identify the frictional gasket(H) and place on themounting stand(E)- Place the mounting base(D) on a hard flat surface.Insert mounting stand(E) into the mountingbase(D) until a click is felt and heard.- Align the arrow on the mounting stand(E) withthe arrow on the mounting plate(I), inserting themounting pin(F) through both to lock them together(Fig 3).- Push the mounting pin cap(G) into the open endof the mounting pin(F). The inside edge of the pincap(G) should be flush with the mounting plate(I).2. Choose a location to mount the solar panel(B),ensuring the solar panel extension cord(M) will reachthe lighting system. For best results the solar panelshould face south, and be clear of any obstructionsthat may impede exposure to sunlight. The bracketprovides nearly 360° of rotation, and 120° of tilt.3. Mount the assembled bracket onto a solid surface,using four of the mounting screws(J) (Fig 4).4. Slide the solar panel(B) onto the solar panelmounting plate(I) until an audible click is felt andheard (Fig. 5). Make any final adjustments to thepanel to optimize exposure to sunlight.Lighting System1. Before installing, check to ensure the included solarpanel extension cord(M) will reach the solar panelinput on the endcap (Fig. 6 ).2. Mount your lighting system choosing one of threemethods: Direct Mount, D-Ring, or Bracket Mount.PACKAGING CONTENTS/CONTENIDO DEL PAQUETEITEMS REQUIRED(Purchase separately)• Phillips screwdriver• 3/16” drill bit (for anchors)• Hammer (for anchors)PRODUCT OVERVIEWThis lighting system is designed for off-grid operation, utilizing an integrated rechargeable li-ion battery pack and dimmer control for longer periods of use between charging. The batterypack can be charged either with the included solar panel, which converts sunlight into energy,or with an external USB power supply (purchased separately). This system features anintegrated 360° motion sensor that turns the light on automatically when motion is detectedat night or in the dark, and can also be used without the motion sensor, allowing the light toremain on regardless of motion events or ambient light levels.WARNINGS AND CAUTIONSINSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS.To reduce the risk of fire or injury to persons, read and follow these instructions:• DO NOT disassemble the lighting system, housing or components• DO NOT dispose of this product in fire. Batteries inside this product may explode or leak.• DO NOT puncture, tamper with, or attempt to modify the battery pack.• DO NOT install or use this system near sources of excessive heat• Lithium-Ion batteries must be disposed of in accordance with local waste ordinances andregulations.• DO NOT operate a luminaire with a missing or damaged lens.• DO NOT cut, tamper with, or attempt to modify the solar panel wire or USB cable.• For indoor or outdoor use.SAVE THESE INSTRUCTIONS.FOR BEST RESULTS• Allow fixture to receive three full days of sunlightbefore use.• Locate solar panel in an area that will receive themaximum amount of sunlight during the daylighthours. The solar panel mustreceive at least 3-4 hoursof direct sunlight daily.A. Light fixtureLuminaireLuminariaENGLISHFig. 1B. Solar panel with 3ft. cordPanneau solaire aveccordon de 0,9 m (3 pi)Panel solar con cable de3 pies (0,91 m)C. (2) Mounting brackets(2) Supports de montage(2) Soportes de montajeD. Mounting baseBase de montageBase de montajeWPS2040MG. Mounting pin capCapuchon de goupillede montageTapa para clavija demontajeI. Mounting platePlaque de montagePlaca de montajeE. Mounting standSocle de montagePlataforma demontajeH. Mounting friction gasketJoint de frottement de montageArandela de fricción de montajeJ. (8) Mounting screws(8) vis de montage(8) Tornillos de montajeK. (4) Drywall anchors(4) dispositifs d’ancragepour cloison sèche(4) Anclajes para panel de yesoL. 6ft.USB CableDe 1,8 m (6 pi) Câble USBCable USB de 6 pies (1,8 m)M. 17ft. Solar panel extension cordDe 5 m (17 pi) Rallonge électrique pour le panneau d’alimentationCable de extensión para paneles solares de 17 pies (5,18 m)F. Mounting pinGoupille de montageClavija de montajeFig. 2Fig. 3Fig. 4Fig. 5E ---H ---D --- CLICKGIFD ---JB----IEI