Eaton CGLine+ Web-Controller Installation And Operating Instructions Manual

197 Common operation of the web screensInstallation and Operating Instructions CGLine+ Web-Controller 40071860236 (E) February 2019 www.eaton.comIn the menu “Commands”1 all commands can besent to CGLine+ single lumi-naires. It is possible to sendthe commands to all lumi-naires or to one line, zone oreven to a single luminaire.2 :Status display of the totalsystem and the pot.-free IN/OUT puts.The following commands 3 can be set:n Block: Emergency light function and maintained mode aredeactivated, e.g. during idle operating timesn Rest mode: During a mains failure (luminaires are in emer-gency mode), the rest mode will switch OFF the luminaires.If mains return, the luminaires will go back in normal mode.To the next mains failure, the luminaires switch again toemergency mode.n Release / Relight: Release of the blocking or rest modefunctionn Start functional test: Specified luminaires start a functiontestn Start duration test: Specified luminaires start a batteryduration testn Stop FT / DT: Function tests or duration tests are abortedn Switch maintained mode ON / OFF: Luminaires in main-tained mode (L’ applied) can be switched ON or OFF (ifluminaire supports this function)n Update luminaire status: Actualisiation of the luminaire sta-tus of all luminairesn Update luminaire type: Actualisation of luminaire typeinformation7 8 Switching command screen12 3 4n Search all lamp: Completely new luminaire search – cau-tion: old configurations are overwritten. All luminaires willbe addressed with a logical address from 1 up to 200 or 1up to 400.n Search new lamp: Starts a luminaire search and onlyadds newly found luminaires. All new luminaires will beaddressed with a logical address from last existing lumi-naire up to 200 or up to 400.n Search initialized lamp: Already addressed luminaires keepstheir addresses after searchn Load config PC soft: Load a configuration which was cre-ated by the CGLine+ PC software. The config file must havethe filename „config.xmlSelection of luminaires to be controlled 4 :n Line: Selection of luminaire lines 1 to 4n Zone: Selection of luminaire zone 2 to 16n Luminaire: Selection of single luminaires in the line andzonen If “All” is selected: Command applies to all luminaires