227 Common operation of the web screensInstallation and Operating Instructions CGLine+ Web-Controller 40071860236 (E) February 2019 www.eaton.com712 General device settingsOn the General tab 2 inthe configuration menu1 the desired countrylanguage can be set via thedrop down menu 3 .It is also possible to modifyor define the password 4for 2 access accounts toset the date and time set-tings of the CGLine+ Web-Controller 5 .To modify the passwords 4the corresponding accountis selected. Firstly the oldpassword must be set. Thenew password is then savedvia “Save” after it has beeninput a second time.In the network configura-tion page 1 it is possibleto configure all necessarynetwork settings. The basicIP settings are alreadydescribed in the manual forfirst commissioning.For tests to be implemented at the correct times and to ensure that the inspection book entriesare chronologically correct, it is necessary after the commissioning to correctly set the date and21 453713 Network (settings)Follwing settings are possible:n DHCP: (Dynamic Host Control Protocol) if a DHCP is inthe network available, it is possible to activate DHCP.During booting the device will get an IP-address from theDHCP server. Please note: The assigned IP address mustbe known, to open the website of the CGLine+ Web-Controller!n Local host name: Any identification name of the Controllern IP address: IP address in IPV4 format xxx.xxx.xxx.xxx, nor-mally provide by the IT-department, factory default is192.168.1.200n Subnet mask: Normally provide by the IT-department, fac-tory default is 255.255.255.0 (Class C)n Gateway: Gateway address to communicate to othersubnets, normally provide by the IT-department, factorydefault is 192.168.1.1n Primary DNS (Domain Name System): Normally provideby the IT-department. DNS provides a name resolution fornetwork devices.n Secondary DNS: Second DNSn MAC-address of the CGLine+ Web-Controller: Fixed identifi-cation no. of the web-controller in a network.1