Eaton CROUSE-HINDS Series Installation & Maintenance Information

Also see for Crouse-hinds series: Operating instructions Instruction manual Operating instructions Operating instructions Instruction manual

Contents

Eaton CROUSE-HINDS Series Installation & Maintenance Information Manual pdf 2 page image

PIVOT1/2-13 BOLT5/16-18 ANGLE BOLTLOOSEN BOLTS TO SETFLOODLIGHT ANGLEFigure 3IF 1845 • 03/19 Copyright® 2019, Eaton’s Crouse-Hinds Division Page 2LOWER HOUSING UPPER HOUSINGBLACK/WHITE2X2 POLE SPLICECONNECTOR3X 3 POLE SPLICECONNECTOR(YELLOW/BLACK) (YELLOW/RED)GGRAY (-)PURPLE (+)BLACK(DC-)WHITE(DC+)GREEN/YELLOWG(GREEN/YELLOW)DIMMING LEADS0-10 VDC SIGNAL10V = 100% LIGHT OUTPUTDRIVEROUTPUTLNL(BLACK)N(WHITE)+ (RED)- (BLUE)LED PCB 1P4 +P1 -INPUTBLACK/WHITE2X3 POLE SPLICECONNECTOR2X2 POLE SPLICECONNECTOR3 POLE SPLICECONNECTOR(YELLOW/BLACK) (YELLOW/RED)GG N LGRAY (-)PURPLE (+)BLACK(DC-)WHITE(DC+)GREEN/YELLOWG(GREEN/YELLOW)DRIVEROUTPUTLNL(BLACK)N(WHITE)+ (RED)- (BLUE)LED PCB 1P4 +P1 -LINENEUTRALPOSITIVENEGATIVEGROUNDSUPPLY WIREINPUTDIMMING LEADS0-10 VDC SIGNAL10V = 100% LIGHT OUTPUT3X2 POLE SPLICECONNECTOR3X2 POLE SPLICECONNECTOROPEN TERMINALS FOR THRU WIRINGFROM FIXTURE TO FIXTUREHEATSINK HEATSINKWIRING DIAGRAM3. Re-install back cover/heat sink and tighten all nine (9) mounting screws to 22 in.-lbs. (2.5 N-m). Be sure wires are not pinched during cover installation.• Replace any damaged or missing cover screws. Use only stainless steel#10-24 x 0.75”cover screws.4. To make final vertical adjustment, loosen the pivot bolts on the floodlight yoke toposition floodlight at the desired angle. See Figure 3.NOTE: Yoke mounting range is 45 degrees back to 60 degrees forward.5. Rotate the floodlight housing to the desired position.6. Tighten the two (2) 1/2-13 pivot bolts to 45 ft-lbs. (61 N-m).7. Tighten two (2) 5/16-18 angle marker bolts, to 138 in-lbs. (15.6 N-m).8. Turn power on.Figure 2WARNINGTo avoid overheating of the floodlight:Do not position the floodlight beyond the aiming range limits.60°45°105°VERTICALAIMING RANGE60° BEFOREVERTICAL45° PAST