Eaton CROUSE-HINDS Series Installation & Maintenance Information

Also see for Crouse-hinds series: Operating instructions Instruction manual Operating instructions Operating instructions Instruction manual

Contents

Eaton CROUSE-HINDS Series Installation & Maintenance Information Manual pdf 3 page image

With Visor OnlyWith Guard OnlyVISOR INSTALLATION INSTRUCTIONS1. Remove power from floodlight.2. Place floodlight face up.3. Carefully align visor with four (4) screw holes at the top of the fixture shown inFigure 7.GUARD INSTALLATION INSTRUCTIONS1. Remove power from floodlight.2. Place floodlight face up.3. Carefully align guard with four (4) screw holes on each side of the fixture shownin the image above.4. Install screws provided with guard, taking care to not scratch the finish of thefloodlight. Torque to 19 in.-lbs. (2.2 N-m).5. Install floodlight per above instructions.• Wire guard catalog number: P62.NOTE: Guard can be installed before or after floodlight has been in operation.Figure 5Figure 6Figure 7DIMENSIONS438.817.28171.86.76457.218.001275.0025410.004X14.55609.624.00389.815.35Figure 4With Visor and GuardMAINTENANCE• Perform visual, electrical and mechanical inspections on a regular basis. Theenvironment and frequency of use should determine this. However, it isrecommended that checks be made at least once a year. We recommend anElectrical Preventive Maintenance Program as described in the National FireProtection Association Bulletin NFPA 70B: Recommended Practice for ElectricalEquipment Maintenance (www.nfpa.org).• The lens should be cleaned periodically to ensure continued lighting performance.To clean, wipe the lens with a clean, damp cloth. If this is not sufficient, use amild soap or a liquid cleaner such as Collinite NCF or Duco #7. Do not use anabrasive, strong alkaline or acid cleaner. Damage may result.• Visually check for undue heating evidenced by discoloration of wires or othercomponents, damaged parts or leakage evidenced by water or corrosion in theinterior. Replace all worn, damaged or malfunctioning components and cleangasket seals before putting the luminaire back into service.• Electrically check to make sure that all connections are clean and tight.• Mechanically check that all parts are properly assembled.REPLACEMENT PARTSCrouse-Hinds Champ LED floodlights are designed to provide years of reliable lightingperformance. However, should the need for replacement parts arise, they are availablethrough your authorized Crouse-Hinds distributor. Assistance may also be obtainedthrough your local Crouse-Hinds Sales Representative or the Crouse-Hinds SalesService Department, 1201 Wolf Street, Syracuse, New York 13208, Phone 866-764-5454.VisorVisorscrewsGuardWireguardscrewsEaton’s Crouse-Hinds Division IF 18451201 Wolf Street, Syracuse, New York 13208 • U.S.A. Revision 1Copyright © 2019 New 03/19All statements, technical information and recommendations contained herein are based on information and tests we believe to be reliable. The accuracy or completeness thereof are not guaranteed. Inaccordance with Eaton’s Crouse-Hinds Division’s “Terms and Conditions of Sale,” and since conditions of use are outside our control, the purchaser should determine the suitability of the product for his intendeduse and assumes all risk and liability whatsoever in connection therewith.4. Install screws provided with visor, taking care to not scratch the finish of thefloodlight. Torque to 19 in.-lbs. (2.2 N-m).5. Install floodlight per above instructions.• Visor catalog number: DSV2.NOTE: Visor can be installed before or after floodlight has been in operation.