Eaton K1121V10 Instruction Leaflet

Fixing CentresSuspension Ceiling FixingFix ceiling bossmounting surfaceusing suitablewood screwFeed 1-5m long wireinto body as shown- screw body intoceiling bossa) Follow procedures ‘a’ to ‘c’ as per ‘SurfaceBracket Installation’.b) Fix suspension wire to surface (see ‘SuspensionCeiling Fixing’).c) locate the suspension wire thread throughthe central surface bracket hole, and securewith supplied M4 nut supplied. Offer theLeat up to the surface brackets and fixSuspension Wire Installation3c) Disconnect the connecting blockfrom the geartray to the housing.Then fully remove the geartray.a) Remove diffuser using thesuction cup (supplied) positionedat the centre of the diffuser.(Stand alone only)b) Using a screwdriver, gentlydisengage the geartray usingthe slotted tabsFixing Centres1.0m1.5m2.0m700mm2700mm + central fixing3.0m1200mm1700mmd) Once spring clips are secure, fix housing into the spring clips.Ensure the spring clips are located above the 21mm diameterholes in the back of the housing, for future removal.(see table for hole locations).e) Wire (as shown in section 4)supply cable into luminaire,re-connect the connectingblock and fix geartray anddiffuser back into place2 Surface Bracket Installation IMPORTANT DO NOT REMOVE ENDCAPSDecember 2019LeatInstruction Manual - K1121V10

/ 4

Related manuals for Eaton K1121V10