Eaton Network Card-MS Quick Start Instructions

Also see for Network Card-MS: User guide Quick start

Contents

Eaton Network Card-MS Quick Start Instructions P-164000507—Rev 1 7Section 4 Initialize the Card ConfigurationNote: These instructions are for HyperTerminal, but you can use the terminalemulation program of your choice, such as HyperTerminal or PuTTY.Note: Before you start initializing the card configuration, you will need to knowwhich COM port you are using on your computer.To initialize the card configuration:1. Verify that the serial cable (supplied) connects the card’s Settings/Sensorport to the computer’s COM port. Also verify that the UPS is on and innormal mode.2. Click Start in the computer Start bar. Type Device in the search box. SelectDevice Manager in the list above the search box. The Device Manageropens.3. Locate Ports (COM & LPT) in the list and click the adjacent “plus box” toexpand the selection. Make a note of the COM port you are using.4. Open HyperTerminal.5. Respond Yes or No to the message asking if you want to makeHyperTerminal your default terminal emulation program.6. Optional. When the Connection Description dialog box opens, enter a namefor this connection and click OK. Otherwise, click Cancel.7. In the New Connection Window, make the menu selectionFile > Properties. On the screen that displays, select New ConnectionProperties.8. From the “Connect Using...”drop-down list, select the COM port that youare using (see Figure 3).