Eaton Powerware Series User Manual

Also see for Powerware Series: Installation and operation manual User guide User guide User guide User guide

Contents

INSTALLATIONEaton® PowerPass® Distribution Module (2500/3000 VA) User's Guide 164201798 Rev 2www.eaton.com/powerquality21To hardwire the PDM1-HV-US-HW (EPPDMG3000R-2U-HW) andPDM2-LV-US-HW (EPPDML3000R-2U-HW) models:1. Switch off utility power at the distribution point where the PDM willbe connected. Be absolutely sure there is no power.2. Verify that the Bypass switch on the PDM is in the NORMALposition (see Figure 11 or Figure 12).3. PDM1-HV-US-HW (EPPDMG3000R-2U-HW). (Connect the shortjumper cable (provided in the accessory kit) from the 16A UPSoutput receptacle into the UPS-output connector on the PDM. SeeFigure 11.Plug the attached PDM-to-UPS cord into the input connector on theUPS rear panel.PDMUPSPDM-to-UPS CordBypass Switch UPS-Output ConnectorUPS-Input ConnectorInput andOutput Wiring16A UPS Output ReceptacleFigure 11. Typical High-Voltage Hardwired Installation [PDM1-HV-US-HW(EPPDMG3000R-2U-HW) Shown]