Eaton SC100 Operation Handbook

Also see for SC100: Installation and operation guide Installation and operation guide Operation handbook

Contents

CommunicationsCopyright © 2008-2011 Eaton Corporation. All Rights Reserved.IPN 997-00012-63C August 2011 516 Press OK. DCTools/PowerManagerII will now connect to the SC100.7 See System Operation on page 13 for details of the SC100 control and monitoring functionsavailable via DCTools. For help using DCTools press F1.8 If required, access to the SC100 via DCTools or PowerManagerII can be password controlled.See Write Access Password on page 53.GSM Modem CommunicationsConnections The PC modem may be external to the PC (as shown) or internal. SC100 system controller PC/laptop with PowerManagerII and/or DCTools. RS232 modem cable (straight-thru). If access toXS1 is restricted use a DB9 ribbon cable extension(Farnell part number 869-6411). GSM modem ModemOptional: SMS text capable GSM cell phone SMS text message "P" or "p" Power status text messages Alarm text messagesSC100 Setup Not all modems are suitable. If your modem does not operate correctly check the modem setupstring. Contact your Eaton dc product supplier or Eaton for further assistance. See WorldwideSupport on page 75.► To enable modem communications1 Connect to the SC100 with DCTools (see details on page 9).2 Go to Communications.3 Click on + to expand Modem. Configure the following settings:Enable Modem: EnabledModem Power Reset: Optional. If this is enabled, then the SC100 will attemptto reset a non-operating modem by turning its powersupply off and on using digital output 2.Modem Set Up String: The string sent to the modem on reset.