Eaton XB10 Technical Manual

3Xenon beacon - Xb10 TM102.L May 2022 www.eaton.comXenon beacon - XB10English5.0 Certification/approvalsIECEx unitsEx d unit (IEC certification No. IECEx BAS 10.0086X)10J:- Ex d IIB T4 (-55°C to +65°C) Gb15J:- Ex d IIB T4 (-55°C to +50°C) GbEx de unit (IEC certification No. IECEx BAS 10.0087X)10J: Ex db eb IIB T4 (-50°C to +65°C) Gb15J: Ex db eb IIB T4 (-50°C to +50°C) GbThe IECEx certificate and product label carry the IECExequipment protection level markingGbWhere Gb signifies suitability for use in a Zone 1 surfaceindustries area in the presence of gas.ATEX unitsEx d unit (ATEX certification No. BAS00ATEX2204X)10J:- Ex d IIB T4 (-55°C to +65°C) Gb15J:- Ex d IIB T4 (-55°C to +50°C) GbEx de unit (ATEX certification No. BAS00ATEX2226X)10J: Ex db eb IIB T4 (-50°C to +65°C) Gb15J: Ex db eb IIB T4 (-50°C to +50°C) GbThe ATEX certificate and product label carry the ATEXgroup and category marking:II 2 GWhere:Signifies compliance with ATEXII Signifies suitability for use in surface industries2 Signifies suitability for use in a zone 1 areaG Signifies suitability for use in the presence of gases6.0 Special conditions for safe useA. Exd units: Certificates BAS00ATEX2204X & IECExBAS 10.0086XI. The mating thread of any cable entry device unusedwith this apparatus must exceed 12mm in length.II. Painting and surface finishes, other than thoseapplied by the manufacturer, are not permitted.B. Exde units: Certificates BAS00ATEX2226X & IECExBAS 10.0087XI. Not more than one single or multiple strand lead shallbe connected into either side of any terminal, unlessmultiple connectors have been joined in a suitablemanner, e.g. two conductors into a single insulatedcrimped boot lace ferrule.II. Leads connected to the terminal shall be insulatedfor the appropriate voltage and this insulation shallextend to within 1mm of the metal of the terminalthroat.III. All terminal screws, used and unused, shall be fullytightened down.IV. Minimum creepage and clearance distances betweenthe terminals and adjacent conductive parts (includingcable entry devices) must be at least 5mm.V. Painting and surface finishes, other than thoseapplied by the manufacturer, are not permitted.These units also have the following approvalsMain Harmonics (AC) to EN61000-6-3:2007/IEC61000-3-2:2006Conducted Emissions (DC) to EN61000-6-3:2007Radiated Field Immunity (DC and AC) to EN61000-6-2:2005/IEC61000-4-3:2002 + A1:2002Electrical Fast Transients/Bursts (DC and AC) toEN61000-6-2:2005/IEC61000-4-4:2004Dips and Interruptions (AC) to EN61000-6-2:2005/IEC61000-4-11:2004Ingress protection IP66 to BS EN 60529:1992Ingress protection IP67 to BS EN 60529:2001