3. Installation3.3 Mounting3.3 MountingNOTICEArrange for a professional technician to mount the device.CAUTIONINSTALLATION CUT-OUTThe mounting cutout must be located in a position that will not defeat thepurpose of stabilizing webs or other reinforcing elements in the controlpanel. If necessary, reinforcing elements must be installed/added.An IP65, Nema 4x or Nema 12 degree of protection will only be ensured ifthere is sufficient stiffness, the device is properly mounted using the originalfixing material, and the gasket has a proper seatl Minimum sheet thickness of control panel panel where the device will be flushmounted:2 mm (0.08") ≦ d ≦ 5 mm (0.2")3.3.1 Fixing and sealingMake sure to check that the "Mounting", page 36 are being met.Make sure that the mounting cutout has the right size.Check the Polyurethane foam gasket for damage and make sure it is resting cor-rectly inside the enclosure groove.Missing parts or damageIf you notice anything wrong, please contact your distributor orEaton Service +49 (0) 180 5 223822 (de,en)36 XV300 12/15 MN048017 EN www.eaton.eu
