Eaton Xanura BSX1 Manual

13MBO 1991 492-401 DASetting the number code for the addressUNIT/OFF Press the key for 5 seconds.no longer than 3 sec. pauseUNIT/OFF Press the key as often as required for the address andkeep it pressed down the last time (press key briefly fivetimes for address 5 and keep pressed down fifth time).…Appliance address is stored.Setting the letter code for the addressHOUSE/ON Press the key for 5 seconds.no longer than 3 sec. pauseHOUSE/ON Press the key as often as required for the address andkeep it pressed down the last time (press key briefly threetimes for address C and keep pressed down third time).…System address has been stored.MountingThe movement sensor can be mounted inside or outside at a heightof approximately 2 metres.Mount the movement sensor as follows:• Use a small screwdriver or similar (see Figure A) to remove thetransparent cap on the protective cover.HOUSE/ON UNIT/OFFA B14MBO 1991 492-401 DAThe LED flashes the same number of times that the key waspressed for the specified address (e.g. once for address 1).The LED flashes every time the key is pressed and after about3 seconds as often as the key was pressed for the specified address(e.g. 5 times for address 5).The LED flashes the same number of times that the key waspressed for the specified address (e.g. once for address A).The LED flashes every time the key is pressed and after about3 seconds as often as the key was pressed for the specified address(e.g. 3 times for address C).• Unscrew the cover and fit the movement sensor with the2 screws supplied (see Fig. B).• Install the 2 batteries.Depending on the setting, the movement sensor will switch onthe light when movement is detected at any time, or only whenit is dark. The switch signals are sent by radio to the CentralAlarm Unit.The switch off time can be set between 1 min. and 256 min.CommissioningOnce the 2 batteries have been fitted the movement sensor isactivated. In the default position, address A1 is activatedwhenever a movement is detected (day and night) and, oncethe last movement has been detected, the light on address A1will switch off after 1 minute. To test this press the"HOUSE/ON" and "UNIT/OFF" keys. When you press the"HOUSE/ON" key the light on address A1 switches on (LEDflashing), but if you press the "UNIT/OFF" key the light onaddress A1 switches off (LED flashing).15 MBO 1991 492-401 DAXanura™ Movement sensor, RF type BSX1Adjusting the movement sensorUNIT/OFF Briefly press the key.HOUSE/ON Press the key for 5 sec.HOUSE/ON Release the key.HOUSE/ON Press once and keep pressed down for 3 sec.orpress twice and keep pressed down for 3 sec. second time.HOUSE/ON Release the key.Adjusting the switch-off timeUNIT/OFF Press the key briefly.HOUSE/ON Press the key for 5 sec.HOUSE/ON Release the key.HOUSE/ON Press once and keep pressed down for 3 sec.orpress twice and keep pressed down for 3 sec. second time.… or …press nine times and keep pressed down for 3 sec. the ninth time.HOUSE/ON Release the key.Flashes once for 1 minuteFlashes twice for 2 minutesFlashes three times for 4 minutesFlashes 4 times for 8 minutesFlashes 5 times for 16 minutesFlashes 6 times for 32 minutes

/ 6

Related manuals for Eaton Xanura BSX1