Standard Fitting Double Sided Legend FittingSafe Operation1. Check the rating label for voltage and frequency before connecting this luminaire to the electricalsupply.2. Ensure that the mains supply is switched off when working on this luminaire, whether installing orcarrying out any other servicing.3. To prevent damage to driver, do not mix with conventional magnetic ballasts on the same electricalcircuit.4. Where use in more onerous situations is required, e.g. In part-completed buildings before “drying-out” iscompleted, or areas where ambient temperatures are outside the normal temperature range, thenconsult our Sales Office.5. Ensure the fixing is adequate for the luminaire weight.6. The change mode of operation from mains to emergency is automatically changed to emergency mode by theintegral PCB control gearServicing and Disposal1. At commissioning and handing over of installation ensure that a copy of these instructions is presentedto the authority responsible for the operation and maintenance of the luminaries.2. Servicing, e.g. cleaning, must only be carried out after the electricity supply has been switched off. Itmust not be assumed that luminaries with lamps not lit are switched off-always check before servicing.3. Cleaning should be carried out at regular intervals to ensure that dirt does not accumulate to an extentthat will impair the thermal safety or optical performance of the luminaire. Regular cleaning will alsoensure that the optical performance of the luminaries is maintained.4. Avoid touching the LED. To clean - Blow surface with either dry air or nitrogen gas.5. At the end of life the luminaire is classed as WEEE under directive 2002/96/EC and should be disposedof in accordance with local legislation.Battery LifePerformance of the luminaire is dependent on the use of the correct type of high temperature Nickel Cadiumbattery. oBattery life may be impaired if the luminaire is mounted in an ambient temperature greater than 25 C. Store theo oluminaire or battery between O C and 25 C. Replace with high temperature Nickel Cadium battery to themanufacturer's recommended part number. Take care not to damage the sleeving. The battery should be replacedwhen the rated duration is no longer achieved.Warning: When disposing of the battery do not pierce, incinerate or short circuit. The battery should be disposedof in accordance with recognised disposal methods.Note: The LEDs are non-replaceable but the batteries can be replaced by a competent person.Luminaire CleaningEnd of Life and Components DisposalWEEEIP65 Product luminaires comply with EN60598-2-22 and are suitable for use in normal interior and exterior conditions,o o For self contained variants - This luminaire has an ambient temperature range of -5 C to 25 Co o For slave variants - This luminaire has an ambient temperature range of -15 C to 40 CInstruction Leaflet K905V7i-P65June 2017K905V7EatonWheatley Hall Road, Doncaster, South Yorkshire, DN2 4NBSalesT: +44 (0)1302 303303F: +44 (0)1302 367155E: sales@cooper-ls.comGeneral+44 (0)1302 321541+44 (0)1302 303220technical@cooper-ls.comInternational Sales+44 (0)1302 303250+44 (0)1302 303251export@cooper-ls.comInstruction Manual - K905V7June 2017i-P65