i-on16Page 24Appendix I. RecordingSpeech MessagesTo record the speech messages you wish the i-sd01 speech dialler to use enter Installer mode andselect Reporting – Speech Dialler – Messages.There are five messages slots available: The HomeMessage and Messages 1 to 4. Within eachmessage you can use one of the following options:Record Message Press to start recording. Thecontrol unit starts recording from the built inmicrophone. The display shows a progress barindicating how long you have left to record. Press to end recording.Play Message Press to play back the message.Delete Message Press to delete the message.When the display asks “Delete Message?” press .Use Lid Tamper This puts the control unit into aspecial mode where the tamper switch controls therecording and playback of the current message.Use this mode if the end station is an inconvenientdistance from the keypad.1. Start with the end station lid off and the tamperswitch open.2. At the keypad select Use Lid Tamper and press.3. At the end station hold down the tamper switch.When the red LED on the I-SD01 glows reciteyour message.4. Release the tamper switch.5. Pulse the tamper switch briefly.The I-SD01 plays back your recording.6. Go back to the keypad and press .7. If required, replace the end station lid. DO NOTreplace the end station lid until you have left the“Use Lid Tamper” mode.www.coopersecurity.co.ukProduct Support (UK) Tel: +44 (0) 1594 541978.Available between:08:30 to 17:00 Monday to Friday.Product Support Fax: (01594) 545401email: techsupport@coopersecurity.co.ukPart Number 12309432 6/1/2014