FANOX SIA-B Series User Manual

Contents

FANOX SIA-B Series User Manual Manual pdf 79 page image

www.fanox.com Rev. 07 79/1387.3. LED indicatorsThe SIA-B front panel is provided with 4 configurable LED pilot that by default show:LEDS DEFAULT CONFIGURATIONLed 1 ReadyLed 2 Ground tripLed 3 Phase TripLed 4 CB SF6 Gas LowFew situations can occur that involve the activation of different LEDs, this is, it can be more thanone led activated at the same moment. It is possible to verify the correct running of the LEDs viatest menu.7.4. LCD and keypadThe front of the SIA-B relay is fitted with an alphanumeric LCD screen, measuring 20x2. This screenprovides the user with access to read information about the settings parameters, measurements,state and events. The whole information is organized in a system of menus.A keypad is fitted to the relay front panel, which can be used to access the information shown onthe LCD screen and to navigate through the menu system.This keyboard is provided with 6 keys that can be used to navigate through the different menus andto change the setting parameters. The ▲ ▼ and ◄ ► keys can be used to navigate through thedifferent menus, the different options in each menu and the different values for the settingsparameters.The “OK” key is used to access the menus and the different options, as well as to approve changesto values. The “C” key is used to delete and to go back through the menu levels.As well as the 6 keys, there is also a “Reset” key. When “Reset” is pressed, leds and outputs arereset (if they are activated and the reason of their activation is clear) and the key can also be usedto delete all of the events from the “Events” menu and fault reports, from “Faults” menu.7.5. SICom Communications programThe SICom program works with the Windows®, Windows 7, Windows 8 and Windows 10 operativesystems.The following operations can be carried out using the SICom program:• Status reading• Measurement reading• Reading and changing settings• Reading and changing configuration• Reading and deleting events• Reading and deleting DFR (fault reports and COMTRADE files)• Changing the user passwords• Loading settings files