PrimeraPro readily accepts five different sizes ofprint media: A-size (Letter), A4-size, A-long(Letter-long), A4-long, and Legal-size. The A-long,A4-long, and Legal-size print media are simplyextended-length sheets which allow for a largerprintable area. FARGO wax thermal transparencyfilm and T-shirt transfer paper are only available inthe A-long or A4-long sizes. Only the dye-sublimation paper shipped with the 4-color dye-sublimation ribbon is available in the Legal-sizepaper.Your PrimeraPro has an internal mechanical adjust-ment that is factory-set for either A-size or A4-sizepaper. If you need to change an A-size unit (all 110/120VAC units) to an A4-size unit (all 220/250 VAC units)or vice versa, refer to the following instructions: Pleasenote that all 220/250 VAC units must be internally set tothe A-size in order to print onto the Legal-size dye-sublimation paper.1. Open the top cover and remove the ribbon cartridge.2. With the Paper Input Tray down, and the PaperOutput Tray (the clear plastic tray) removed,unscrew and remove the only visible screw on theFront Frame Plate of the printer.3. Gently slide the entire bronze-colored OutputAssembly, located just above the Paper Input Tray,out about five centimeters (steps 1–3 are illustratedup to this point on page 70 of this manual).4. Looking inside the printer, the Paper Feed Rollerand the two black brackets which attach it to theprinter should now be visible.5. To adjust from A to A4-size print media, gentlyslide the left bracket to the right approximately .25”.To adjust from A4 to A-size print media, do just theopposite. The internal A/A4 adjustment is nowcomplete. Reverse these steps to reassemble.4. Slightly bend thePaper Output Tray justenough to place theremaining mountingpost into the othermounting hole. Lowerthe tray into place.While care should betaken not to bend thetray too much, don’tworry; the tray is noteasily broken.F. Loading Paperor TransparencyFilm23