FabIATech Corporation7Chapter 2 Hardware InstallationThis chapter introduces the system connectors & jumper settings, and guides you toapply them for field application.Before InstallationBefore you install the system, make sure you follow the following descriptions.1. Before removing the cover, shut down the operation System and disconnectthe power cords.2. Install or unplug any connector, CPU, PCI Card, Disk On Module and hard diskbe sure that the power cable is disconnected the system. If not, this maydamage the system.3. Installing a heat sink is necessary for heat dissipation from your CPU. If heat sinkis not mounted, this may cause the CPU fail due to over-heating problem.4. The ESD (Electricity Static Discharge) may be created from human body thattouches the board. It may do damage to the board circuit.
