Falcon Classic 110 gas User Manual

Also see for Classic 110 gas: User guide User's guide & installation instructions User's guide & installation instructions

15AustraliaTo fi t the small inner burner, find the largerelectrode notch in the burner rim. Line this up withthe white ignition electrode and place the innerburner on the large base ring.A electrode notch B ignition electrodeNow fi t the two trim rings, making sure that theyare sitting down properly.GriddleAlways clean the griddle after use. Allow to coolcompletely before removing. Immerse the griddleplate in hot soapy water. Use a soft cloth or, forstubborn stains, a nylon washing up brush.NEVER USE CAUSTIC OR ABRASIVE CLEANERS ASTHESE WILL DAMAGE THE SURFACE.Control Panel and DoorsAvoid using any abrasive cleaners including creamcleaners, e.g. Jif, on brushed Stainless Steel surfaces.For best results use a liquid detergent.The control panel and control knobs should onlybe cleaned with a soft cloth wrung out in cleanhot soapy water - but take care that no surpluswater seeps into the appliance. Wipe with a cleandampened cloth then polish with a dry cloth. Theoven doors should only be cleaned with a soft clothwrung out in clean hot soapy water.Stainless Steel Cookers with window doorsIf the inside face of the glass on window doormodel becomes marked, the oven door front panelcan be taken off so that the glass panels can becleaned.Move the cooker forward to gain access to thesides (see the ‘Moving the cooker’ section of theseinstructions).Open the oven door slightly and remove the frontpanel fixing screws from the door sides (two eachside).stainless steel window doors onlyCarefully lift off the outer door panel. The insideface of the glass panels can now be cleaned - takecare not to disturb or wet the door insulation.Please note that the door is triple glazed but theinner two panels are fixed and should not beseparated. After cleaning carefully refit the outerdoor panel and replace the side fixing screws.The OvensCleaning is easier if carried out while the oven is stillwarm. Before cleaning, cover the burner to preventthe burner holes becoming blocked.The inside of the oven and inner door panel canbe cleaned using any cleaner suitable for enamelsurfaces.Take care not to disturb the oven thermostattemperature sensor at the top of the oven opening.The enamelled oven burner trim (supplied withsome models only) can be removed for cleaning.The oven burner trim hooks onto the front of theoven burner bracket.When refitting make sure that the trim is in themiddle of the front of the oven burner bracket.