49Englishparticularly prone to heat damage and discolouration.We cannot accept responsibility for damage caused bynormal use of the cooker to any material that de-laminatesor discolours at temperatures less than 65°C above roomtemperature.For safety reasons curtains must not be fitted immediatelybehind the cooker.We recommend a gap of 910mm between units to allowfor moving the cooker. Do not box the cooker in; it mustbe possible to move the cooker in and out for cleaning andservicing.A clearance of 130mm is required if the cooker is near acorner of the kitchen to allow the oven doors to open. Theactual opening of the doors is slightly less but this allows forsome protection of your hand as you open the door.Unpacking the CookerDo not take any packaging off the cooker until it is directlyin front of the place it is to be installed (unless it will not fitthrough a door in its outer packaging).Cut the banding straps and lift the cardboard box off thecooker, leaving the cooker standing on the base packaging.See the loose unpacking sheet.Moving the CookerThe cooker is very heavy. Take great care.We recommend two people manoeuvre the cooker. Ensurethat the floor covering is firmly fixed, or removed to preventit being disturbed when moving the cooker around. You willneed the levelling tool.From the back tilt the cooker forward and remove the rearhalf of the polystyrene base pack.Repeat from the front and remove the front half of thepolystyrene base.LOWER THE TWO REAR ROLLERS.First fit the levelling tool on the hexagonal adjusting nut asshown below.Make 10 complete (360º) turns clockwise. (This meansturning and removing the levelling tool 20 times).Make sure you lower BOTH REAR ROLLERS. There are twoadjusting nuts, one for each roller, at both the front bottomcorners of the cooker.Unfold the rear edge of pack base tray. Open the grill doorand the Tall oven door. Grip under the control panel and liftthe front of the cooker.Carefully push the cooker backwards off the pack base.Remove the pack base tray. Position the cooker close to itsfi nal position leaving just enough space to get behind it.