Falcon Classic Deluxe 90 FSD Instructions For Use Manual

54English9. To Change Hotplate TapsDisconnect from the electricity supply.Remove the control panel and hotplate (see 1 & 2).Unplug the FSD lead from the rear of the tap. Undocompression fitting at the rear of the tap. Remove thefi xings that secure the tap to the gas rail. Disconnect theignition switch wiring.Remove the tap. Remove and discard the gasket seal. Fitnew gasket seal to replacement tap. Re-assemble in reverseorder. Check the appliance is gas sound. Check hotplateignition.10. To Change Hotplate Burner InjectorRemove burner cap and head. Remove old jet. Fit newinjector. Reassemble in reverse order. Check appliance is gassound.11. To Change Hotplate Burner ElectrodeLift off pan supports, remove burner cap. Remove thescrew holding the electrode. Pull electrode vertically upsufficiently to grip the lead between thumb and forefinger.Pull off the electrode, but keep hold of the lead. Fit newelectrode to the lead. Fix electrode in burner with screw.Replace burner cap. Check the burner ignition. Replace pansupports.12 To Remove or Change a Hotplate Burner.Remove the hotplate tray (see 2).The burners except the right hand wok burner are mountedon support struts. For these burners, disconnect the burnerfeed pipes at the burner. Remove the screws at the front andrear holding the support struts. Lift the strut and burnersclear. The burners are fixed to the support struts with 2screws. Remove the appropriate burner and fit the newone. Reassemble in reverse order. Check burner operation issatisfactory.Right hand Wok burnerDisconnect the burner feed pipes at the burner. Fit thenew one and reassemble in reverse order. Check burneroperation is satisfactory.13. To Remove an Oven DoorOpen the oven door. Loosen the two top hinge screws.Support the weight of the door and remove the screwnearest the hinge pin. Swing the hinge up and away fromthe hinge pin on the door.Lift the door away from the bottom hinge.Re-assemble in reverse order.When replacing the door ensure that the nylon hinge bushis in position between the hinge pin and the hinge bracketat the both the bottom and top.14. To Change Main Oven Door Outer PanelMove the cooker forward to gain access to the sides.Open the oven door slightly and remove the front panelfi xing screws from the door sides (two each side).Carefully lift off the outer door panel.Remove door handle from panel by unscrewing 2 retainingnuts. Fit door handle to new panelFit panel to door. Reassemble in reverse order.15. To Change the Main Oven Door LatchRemove outer door panel (see 14). Remove screws ‘B’holding latch assembly to inner door panel. Fit new catchand reassemble in reverse order.Check correct door operation.16. To Adjust the Main Oven Door Catch KeepOpen oven door, slacken off locknut at base of keep, andscrew in or out as required until required fit is obtained.Retighten locking nut.