INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.25ArtNo.010-0004 Moving the cookerArtNo.010-0002 Rear roller nutArtNo.010-0010 Lowering the rear rollers (90)x10Fig.7-8Fig.7-6Fig.7-7ArtNo.010-0009 Pushing the cookerFig.7-9ArtNo.342-0002 - Elan - drawer positionFig.7-5Lift up the ends of the plastic clips (one each side) to releasethe catches holding the drawer to the side runners and at thesame time pull the drawer forward and away from the siderunners (Fig.7-5).For safety’s sake push the drawer runners back out of theway. Put the drawer somewhere safe - do not refit it until theinstallation is complete.First fit the levelling tool on the hexagonal adjusting nut(Fig.7-6).Make 10 complete (360º) turns clockwise (Fig.7-7) - thismeans turning and removing the levelling tool 20 times.Make sure you lower BOTH REAR ROLLERS. There are twoadjusting nuts, one for each roller, at both the front bottomcorners of the cooker.Completing the MoveUnfold the rear edge of the pack base tray. Grip the fasciapanel and lift the front of the cooker slightly (Fig.7-8).Carefully push the cooker backwards off the pack base.Remove the pack base. Position the cooker close to its finalposition, leaving just enough space to get behind it (Fig.7-9). DO NOT use the control knobs to manoeuvre thecooker.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level.Place the cooker in its intended position, taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The front feet and rear rollers can be adjusted to level thecooker. To adjust the height of the rear of the cooker use thelevelling tool supplied to turn the adjusting nuts at the frontbottom corners of the cooker. To set the front feet turn thebases to raise or lower.Leave the levelling tool in the storage drawer, so that thecustomer can use it if they wish to move the cooker.