Falcon Elan 110 Dual Fuel User Manual

Also see for Elan 110 Dual Fuel: User guide & installation & service instructions User's guide & installation instructions

Falcon Elan 110 Dual Fuel User Manual Manual pdf 34 page image

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity before servicing. Check appliance is safe when you have finished.32��9. Servicing Disconnect the cooker from the electricity supplybefore servicing, particularly before removing anyof the following: control panel, side panels, ceramichob, or any of the electrical components or coverboxes. Before reconnection, check that the appliance iselectrically safe.1. To Remove the HandrailRemove the plastic blanking plugs (Fig.9-1) and remove thetwo end bracket fixing screws.2. To Remove the Control PanelDisconnect from electricity supply.Pull off all the control knobs. Remove the handrail (see 1).Remove the two cross-headed screws that were hidden by thehandrail end brackets.Open the grill door and right-hand oven door and remove thetwo screws underneath the control panel (Fig.9-2).Pull the control panel forward and support it so that the wiresare not strained.Reassemble in reverse order. When replacing leads, refer to thewiring diagram. Check the operation of the timer, ignition, andoven light switches.3. To Remove the Hotplate TopDisconnect from electricity supply.Remove the pan supports, cooktop burner caps and tops.Remove the screws holding the cooktop burners to thecooktop (but not the spark electrode fixing screws).Remove the two rear cooktop fixing screws ‘B’ on the cookerback under the flue grille, and the four front cooktop fixingscrews ‘A’, (Fig.9-3).Remove the screws holding the flue grille stays.Lift the cooktop clear of the appliance. Replace in reverseorder.Reassemble in reverse order, ensuring that the leads arereconnected.Check for correct burner operation.4. To Remove a Side PanelDisconnect from electricity supply.Remove the control panel (see 2). Pull the cooker forward.Remove the four retaining screws from each panel (two at thefront and two at the rear). The lower front retaining screws(one each side) are situated beneath the lower edge at thefront corners of the side panelsReassemble in reverse order.ArtNo.210-0009 - Classicremoving the handlesFig.9-1Fig.9-3ArtNo.215-0013 - 90 Elan DF - Removing the control panel��0 000Fig.9-2��ArtNo.311-0010 InjectorsFig.9-4A - Jet, B - Internal injector, C - External injectorWok burner (somemodels only)Standard burner