Falcon Elan User Manual

Falcon Elan User Manual Manual pdf 24 page image

24INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.AustraliaMake sure you lower BOTH REAR ROLLERS. There aretwo adjusting nuts, one for each roller, at both the frontbottom corners of the cooker.Unfold the rear edge of the pack base tray. Open thegrill door and right hand oven door so that you can geta good grip on the bottom of the fascia panel as youmove the oven:Grip under the fascia panel and lift the front of thecooker slightly:Carefully push the cooker backwards off the pack base.Remove the pack base tray. Position the cooker closeto its final position, leaving just enough space to getbehind it.Do not use the door handles or control knobs tomanoeuvre the cooker.Repositioning the Cooker followingConnectionIf you need to move the cooker once it has beenconnected, then you need to unplug it and, havinggripped under the fascia panel and lifted the frontof the cooker slightly (as shown above), you need tocheck behind the cooker to ensure that the gas hose isnot caught. As you progress, make sure that both theelectricity cable and gas hose always have sufficientslack to allow the cooker to move.Release the stability chain as you ease the cookerout. When you replace the cooker, don’t forget to refitthe chain and also check behind to make sure that theelectricity cable and gas hose are not caught or trapped.Conversion to LPIf the appliance is to be converted to LP gas, carry outthe conversion at this point. See the conversion sectionof these instructions.LevellingIt is recommended that you use a spirit level on a shelfin one of the ovens to check for level. Ensure that thecooker in its intended position, taking care not to twistit within the gap between the kitchen units, as damagemay occur to the cooker or the units. The front feetand rear rollers can be adjusted to level the cooker.To adjust the height of the rear of the cooker, use thelevelling tool supplied to turn the adjusting nuts at thefront bottom corners of the cooker. To set the front feet,simply turn the bases to raise or lower them.Leave the levelling tool with the customer, so thatthey can use it if they wish to move the cooker again.Fitting the Handles and Front HandrailRemove the 4mm Allen screws from the doors withthe hexagon key tool. Use the screws to fit the doorhandles.The handles should be above the fixings.