Falcon toledo User Manual

Also see for Classic: User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

15ArtNo.320-0008 Removing the oven liningOvensCleaning is easier if carried out while the oven is still warm.Before cleaning, cover the burner to prevent the burner holesbecoming blocked.The inside of the oven and inner door panel can be cleanedusing an approved cleaner (Table 5-1).Take care not to disturb the oven thermostat temperaturesensor at the top of the oven opening (Fig.5-7).The enamelled oven burner trim (Fig.5-8) can be removed forcleaning.The oven burner trim hooks onto the front of the oven burnerbracket. When refitting make sure that the trim is in themiddle of the front of the oven burner bracket (Fig.5-9).‘Cook & Clean’ PanelsThe ovens have panels which have been coated with a specialenamel that partly cleans itself. This does not stop all markson the lining, but helps to reduce the amount of manualcleaning needed.The ‘Cook & Clean’ panels work better above 200 °C. If you domost of your cooking below this temperature, occasionallyremove the panels and wipe with a lint free cloth and hotsoapy water. The panels should then be dried and replacedand the oven heated at 200 °C for about one hour. Thiswill make sure that the ‘Cook & Clean’ panels are workingeffectively.DO NOT use steel wool, oven cleaning pads, or any othermaterials that will scratch the surface.Removing the Panels to Clean the EnamelInteriorSome of the lining panels can be removed for cleaning. Youwill need to remove the shelves before removing the panels.Each side of the oven is fixed with four fixing screws. You donot have to remove the screws to remove the oven linings.Simply lift each side panel upwards and they will slide off thescrews (Fig.5-10). Then pull them forwards.Once the linings are removed, the oven enamel interior canbe cleaned.The Tall OvenTo clean the oven sides, slide out the shelves, unhook thesupports from the oven sides and lift out (Fig.5-11).Fig.5-10Thermostat temperature sensorArtNo.323-0009 - Bray burner shield fittedOven burner trimArtNo.323-00011 - Bray burner front shieldFig.5-7Fig.5-8Fig.5-9ArtNo.320-0022 Tall oven side supportFig.5-11