Falcon toledo User Manual

Also see for Classic: User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity before servicing. Check appliance is safe when you have finished.366 Doors6.1 To Remove the Grill DoorRemove the left-hand side panel (see 1.2). Removethe plinth (4 screws) and the central vertical cover(5 screws). Remove the 2 countersunk screws (1 eachside) securing the grill hinge arms to the front of thegrill chamber.Note: The arms are spring tensioned. Carefully removethe grill door. Retain the gaskets.Reassemble in the reverse order, making sure that thegasket is fitted between the hinge arm and the front ofthe grill chamber.6.2 To Replace the Main Oven DoorOpen the oven door. Support the door and loosen the2 screws securing the upper hinge and gasket to thecooker front (Fig.9-9).nn The door is heavy, so take care.Support the door and remove the screw nearest thehinge pin (Fig.9-10). Swing the hinge up and away fromthe door hinge pin. Lift the door away from the lowerhinge and remove.Reassemble in reverse order.6.3 To Adjust the Main Oven Door AngleThe bottom hinge of the main oven door can beadjusted to alter the angle of the door (Fig.9-11).Loosen the bottom hinge fixing screws and use thenotch and a flat bladed screwdriver to move theposition of the hinge to set the hinge position(Fig.9-12).Retighten the hinge screws.6.4 To Replace the Main Oven Door Outer PanelMove the cooker forwards to gain access to the sides.Open the main oven door slightly and remove the4 front panel fixing screws from the door sides (2 eachside), (Fig.9-13). Carefully lift off the outer door panel.Remove the door handle from the panel by unscrewingthe 2 retaining nuts.Fit the door handle to the new panel.Fit the panel to the door. Reassemble in reverse order.6.5 To Change the Main Oven Door LatchRemove the main oven door outer panel (see 6.4).Remove screws ‘B’, which hold the latch assembly tothe inner door panel (Fig.9-14). Fit the new catch andreassemble in reverse order. Check the door operation.6.6 To Adjust the Main Oven Door Catch KeepOpen the main oven door, slacken off the locknut at thebase of the keep, and screw in or out as required untilthe required fit is obtained. Retighten the locking nut(Fig.9-15).ArtNo.320-0002a Proplus oven door side screwsArtNo.320-0006 Oven door hinge adjustment 1ArtNo.320-0007 Oven door hinge adjustment 2Fig.9-12Fig.9-13Fig.9-11Effect of hinge adjustment – exagerrated for clarityCentreline of hinge pinOven door omitted for clarityArtNo.320-0003 Oven door latchBFig.9-14ArtNo.320-0004 Oven door keepFig.9-15ArtNo.320-0001 Door hinges1ArtNo.320-0001 Door hinges2Fig.9-9 Fig.9-10