GE 18 Use And Care & Installation Manual

Also see for SIDE-BY-SIDE REFRIRATOR 22: Owners and installation manual Owner's manual Use and care & installation guide Owner's manual Use and care & installation guide

GE 18 Use And Care & Installation Manual Manual pdf 15 page image

15Care and CleaningTwo Drawers (on some models)1. Remove the drawer farthestfrom the door.2. Remove the other drawer.On models with a bottom doorshelf that blocks the other drawer,slide the other drawer toward themiddle and remove it.3. Remove the glass cover. Reachin, push the front of the glasscover up and, at the same time,pull it forward as far as it willcome. Tilt it and take it out.4. Remove the drawer frame.(Always remove the glasscover before you take out thedrawer frame.)Lift the frame off the supportsat each side and back, pull itforward, tilt it and take it out.To replace:1. Lower the frame until it restson the supports at each sideand back.2. Replace the drawers.If you removed the drawer slide,replace it with the sloped end atthe front.a. Slide one side of the draweronto the drawer slide.b. Move the slide and drawer allthe way to the hinge side untilthe other side of the drawer restson the frame.c. Slide the other drawer into place.3. Replace the glass cover, pushing its rear edge firmly into the rearframe channel and gently lowering the front into place.FrameDrawer Slide(sloped end)Full-Width Drawer with Plastic Cover (on some models) Half-Width Drawer with Plastic Cover (on some models)To remove the drawer, lift thefront up slightly and pull thedrawer straight out.To remove the cover, lift it off itssupports, pull it forward and up,tilt it and take it out.To remove the drawers,lift the front up slightlyand pull the drawerstraight out.Light Bulb ReplacementA light bulb and socket arelocated at the top of the freshfood compartment opposite thetemperature control panel.Some models also have a bulband socket in the upper left cornerof the freezer compartmentbehind a flexible light shield.To replace either bulb, unplug the refrigerator from its electricaloutlet, remove light shield, unscrew the bulb when cool, and replaceit with a similar size bulb.(continued next page)