GE Multilin B90 Low Impedance Bus Differential System 5-515 SETTINGS 5.2 PRODUCT SETUP5Use the MENU key to go to the user displays menu to view the user-defined content. The current user displays will show insequence, changing every four seconds. While viewing a user display, press the ENTER key and then select the ‘Yes”option to remove the display from the user display list. Use the MENU key again to exit the user displays menu.An example user display setup and result is shown below:If the parameters for the top line and the bottom line items have the same units, then the unit is displayed on thebottom line only. The units are only displayed on both lines if the units specified both the top and bottom line itemsare different. USER DISPLAY 1DISP 1 TOP LINE:Current X ~ AShows user-defined text with first tilde marker.MESSAGE DISP 1 BOTTOM LINE:Current Y ~ AShows user-defined text with second tilde marker.MESSAGE DISP 1 ITEM 1:6016Shows decimal form of user-selected Modbus registeraddress, corresponding to first tilde marker.MESSAGE DISP 1 ITEM 2:6357Shows decimal form of user-selected Modbus registeraddress, corresponding to second tilde marker.MESSAGE DISP 1 ITEM 3:0This item is not being used. There is no correspondingtilde marker in top or bottom lines.MESSAGE DISP 1 ITEM 4:0This item is not being used. There is no correspondingtilde marker in top or bottom lines.MESSAGE DISP 1 ITEM 5:0This item is not being used. There is no correspondingtilde marker in top or bottom lines.USER DISPLAYS → Current X 0.850Current Y 0.327 AShows the resultant display content.NOTE