10About the dispenser. (CFE & CYE Models Only)Dispenser trayImportant Facts About Your Dispenser Do not add ice from trays or bags to the door ice makerbucket. It may not crush or dispense. Avoid overfilling glass with ice and use of narrow glasses.Backed-up ice can jam the chute or cause the door in thechute to freeze shut. If ice is blocking the chute remove the icebucket, poke it through with a wooden spoon. Beverages and foods should not be quick-chilled in thedoor ice maker bin. Cans, bottles or food packages in thestorage drawer may cause the ice maker or auger to jam. To keep dispensed ice from missing the glass, put the glassclose to, but not touching, the dispenser opening. Some crushed ice may be dispensed even though youselected CUBED ICE. This happens occasionally when a fewcubes accidentally get directed to the crusher. After crushed ice is dispensed, some water may drip from thechute. Sometimes a small mound of snow will form on the door in theice chute. This condition is normal and usually occurs when youhave dispensed crushed ice repeatedly. The snow will eventuallyevaporate.If no water is dispensed when the refrigerator is first installed,there may be air in the water line system. Press the dispenserpaddle for at least five minutes to remove trapped air from thewater line and to fill the water system. To flush out impurities inthe water line, throw away the first six full glasses of water.To remove Dispenser Tray Pull Dispenser Tray out until it stops. Locate tab in the center on the bottom and push up. Pull Dispenser Tray assembly out. Lift metal Dispenser Tray out at center notch to clean.To reinstall Dispenser Tray Place the Dispenser Tray cover on top of catch tray andposition under the two plastic retainers on either side. Center Dispenser tray, and align with center guides. Push in until is firmly in place.Water & Ice Dispenser(See About the controlswith temperature settings &About the control features)To Use the Internal Water Dispenser (CWE Models Only)The water dispenser is located onthe left wall inside the refrigeratorcompartment.To dispense water:Hold the glass against the recess.Push the water dispenser button.Hold the glass underneath thedispenser for 2–3 seconds afterreleasing the dispenser button. Watermay continue to dispense after thebutton is released.If no water is dispensed when the refrigerator is first installed,there may be air in the water line system. Press the dispenserbutton for at least 5 minutes to remove trapped air from thewater line and to fill the water system. During this process,the dispenser noise may be loud as the air is purged from thewater line system. To flush out impurities in the water line,throw away the first 6 glassfuls of water.NOTE: To avoid water deposits, the dispenser should becleaned periodically by wiping with a clean cloth or sponge.WARNING Laceration Hazard Never put fingers or any other object into ice crusherdischarge opening. Doing so can result in contacting the icecrushing blades and lead to serious injury or amputation Use a sturdy glass when dispensing ice. A delicate glass maybreak and result in personal injury.