GE Cafe CYE22TSHSS Owner's Manual And Installation Instructions

27Installation InstructionsINSTALLING THE REFRIGERATOR (cont.)GE AppliancesGeneral Electric CompanyLouisville, KY 40225GEAppliances.com Refer to 239D4144P001 Pub No. 31-45474-2 11-12 GEIMPORTANT!The 6 mounting screws (3 on each side) are NOT interchangeable with the center or top hingescrews. Drawer screws have flat washer heads, and other screws have lines/ribs on washer heads.After installation of the freezer door, check for uniform gaps (top and bottom of right and left hand side)with the template provided.In the event of excessive gaps use the following steps to adjust the freezer door.Step 1 - Loosen the 3 screws on each side (right and left) of the freezer door.Step 2 - Adjust set screw clockwise if gap at the top is too big (see template). Turn the set screw using 3/32” hexkey clockwise by quarter to half a rotationStep 3 - Adjust set screw counter-clockwise if gap at the bottom is too big (see template). Turn the set screwusing 3/32” hex key counter-clockwise by quarter to half a rotationStep 4 - Tighten the 3 screws on each side (right and left).Step 5 - Re-check the gaps using the template and repeat steps 1 to 4 if required and complete with step 5.Instructions for adjusting freezer door gaps:Fold here for using template0.600”Template for checking gaps.Gap should be 0.6” or below.Gabarit pour vérifier lesécarts. L’écart doit être de0,6 po (1,5 cm) ou moins.Plantilla para el control deespacios. El espacio deberíaser de 0.6” o inferior.Step 1Étape 1Paso 1Step 4Étape 4Paso 4Set ScrewVis d’ajustementTornillo del Set Step 3Étape 3Paso 3Step 2Étape 2Paso 2Plier ici pour utiliser le gabarit Dóblelo aquí para usar la plantilla