GE Multilin D30 Line Distance Protection System 5-595 SETTINGS 5.2 PRODUCT SETUP5See the figure in the Control Groups section of the Control Elements section later in this chapter for an example of groupactivation.5.2.10 USER-PROGRAMMABLE SELF TESTSFor user-programmable self-tests for CyberSentry, use the Setup > Security > Supervisory menu instead.PATH: SETTINGS PRODUCT SETUP USER-PROGRAMMABLE SELF TESTSAll major self-test alarms are reported automatically with their corresponding FlexLogic operands, events, and targets. Mostof the minor alarms can be disabled if desired.When in the “Disabled” mode, minor alarms will not assert a FlexLogic operand, write to the event recorder, or display tar-get messages. Moreover, they will not trigger the ANY MINOR ALARM or ANY SELF-TEST messages. When in the “Enabled”mode, minor alarms continue to function along with other major and minor alarms. Refer to the Relay self-tests section inchapter 7 for additional information on major and minor self-test alarms. USER-PROGRAMMABLE SELF TESTSDIRECT RING BREAKFUNCTION: EnabledRange: Disabled, Enabled. Valid for units equipped withDirect Input/Output module.MESSAGE DIRECT DEVICE OFFFUNCTION: EnabledRange: Disabled, Enabled. Valid for units equipped withDirect Input/Output module.MESSAGE REMOTE DEVICE OFFFUNCTION: EnabledRange: Disabled, Enabled.MESSAGE FIRST ETHERNET FAILFUNCTION: DisabledRange: Disabled, Enabled.MESSAGE SEC. ETHERNET FAILFUNCTION: DisabledRange: Disabled, Enabled.MESSAGE THIRD ETHERNET FAILFUNCTION: DisabledRange: Disabled, Enabled.MESSAGE BATTERY FAILFUNCTION: EnabledRange: Disabled, Enabled.MESSAGE SNTP FAILFUNCTION: EnabledRange: Disabled, Enabled.MESSAGE IRIG-B FAILFUNCTION: EnabledRange: Disabled, Enabled.MESSAGE PTP FAILFUNCTION: EnabledRange: Disabled, Enabled.MESSAGE SFP MODULE FAILFUNCTION: DisabledRange: Disabled, Enabled.
