GE GBSC0 Technical Service Manual

– 13 –To replace the top door:Install the center hinge on each side.1.Lower the refrigerator door onto the center2.hinge pin. Ensure that the plastic hinge pinthimble is on the center hinge pin or inside doorhinge pin hole located in the bottom of the door.3. Securely tape the door shut with masking tapeor have a second person support the door.4. Route wires through bottom left hinge pin slot.Insert the top hinge pin into the hinge holeon top of the refrigerator door. Make sure thedoor is aligned with the cabinet and oppositedoor. Attach the hinge to the top of the cabinetloosely with the bolts.5. On left-hand doors, pass the wires and waterline through the center hinge pin. Then connectthe water line and 4-pin connector.6. Make sure the gasket on the door is flushagainst the cabinet and is not folded. Make surethe door is straight and the gap between thedoors is even across the front. While holdingthe aligned door in place, tighten the top hingebolts. Replace the hinge cover and screw.Hinge PinBottomLeft HingePin Slot(appearance may vary)4-PinConnector Water LineCenter Hinge PinTop Hinge BoltsHinge Cover9. If the doors remain uneven, turn the adjustablepin to raise or lower the left door to match theright door. Use a 1/4-in. Allen wrench to turn thepin.7. Follow the same procedure on the oppositedoor. There is no water line or hinge cover.8. If the top of the doors are uneven, first try toraise the lowest door by turning the leveling legon the same side as the door until the doors areeven. If the unit rocks, re-adjust the leveling legsuntil the unit is stable.Adjustable pin