GE GHDS830EDWS Technical Service Manual

Also see for GHDS830EDWS: Manual

GE GHDS830EDWS Technical Service Manual Manual pdf 12 page image

– 12 –Reversing the Door SwingNote: These instructions are for changing the dryer so the dooropens from the right side.Tools needed: Standard #2 Phillips screwdriver Tape-tipped putty knife Small flat blade screwdriverBefore you StartUnplug the dryer from its electrical outlet.1 Open the door approximately 170 degrees. With a puttyknife, remove the 4 plastic covers located along the leftside of the front panel and set them aside.2 Remove the bottom screw from each hinge (right side)and partially insert them into the top left side hingeholes.NOTE: All 4 front panel hinge screws will now be in the tophinge holes - 2 on the left and 2 on the right.Plastic Cover (4)Left side offront panel3 Loosen the bottom 2 right side hinge screws. Remove thedoor and place it on a protected, flat surface to avoidany damage. Remove both the Blind Plate and the StrikePlate and install them in opposite positions.4 Remove the 4 door hinge screws, 4 edge screws, and 8inside screws. Lift the inner door upwards using a flatblade screwdriver.Blind plateInner doorStrike plateDoor hingescrewsInner doorOuter doorInside screwsInside screwsEdgescrewsNote: Some doors may have 4 inside screws and 4 additionaledge screws.(Continued next page)